Search results

Still looking for one of those hubcap tab bending tools that used to be available for installing the hubcaps. I think it was a T1130 part number.

http://www.ronsmachineshop.com/Home.html

http://www.ronsmachineshop.com/Home.html

I'm told now that the later sedans had the hinges riveted on to the door side of the hinge. I think that I will just give up on the idea of replacing the hinges. This whole project started because I was unable with two different hinge pin removers to get the pins to budge to install hinge mount...

All 8 of the door hinges on my 31' s/w town sedan have slotted heads on the screws showing on the body side of the hinge and fasteners showing flush with the hinge on the door side. Did they come from the factory this way? This makes it necessary to remove the door trim to replace a hinge.

Thank you.

I would like to see pictures of the wiper from inside the car and outside the car. My Slant Window TS has no wiper at all just the hole on the outside metal piece above the window.

I am looking for an original outside door handle for a 31' SW town sedan that has the key lock in it with a key that works.

I need contact info for Howard Denker.

No, I took it to the locksmith to get a key.

I took the out side door handle with the lock in it to a local locksmith and he said that the insides were corroded enough that he could not get it to turn or be able to put a key in enough to turn it. The handle looks great so I can still use it but I would like to be able to lock the car. It's...

Thanks. I got one of these ordered from Amazon today.

What is the correct size die to use as a thread chaser for the wheel lugs that the lug nuts screw in to? 31 SW Town Sedan.

Could you describe the process and where you got your dies?

When reassembling a '31 side-bowl Zenith carb what is the best lubricant to use on the throttle shaft ends?

I just replaced the door checks on my '31 S/W Town Sedan. I used the Bratton's 32840 arm set and the 32910 arm pad. The old pads were dried out and fell apart. The new ones from Bratton's easily replaced the originals with the two screws provided. The new arms replaced the cheap repo's that...

How to get a hub cap to not be loose when installing on a '31.

Used for the tabs on the hub caps. They seem to have been made by A&L but no longer made.

I am going to replace the gas shutoff valve on my 31 s/w town sedan with indented firewall. What is the recommended sealant to use on the threads where it screws into the outlet of the gas tank?

Does anyone have a setup at home to be able to add gas to the tank from a gas can without pouring from the gas can itself? Hand crank or electric pump. If so what worked well and what didn't? Hard to not drip when pouring from the gas can itself.