Search results

I need to replace steering box on my 48 Ford Car. It has electric power steering. What is a good brand to buy ? Thanks

I am replacing old steering box with a cardone #27-6556. Do I need to buy a new Pitman arm, Thanks

thanks everyone for the help.

LOOKING FOR DIMENSIONS ON 48 fORD CAR REAR HUB. My bearing slides back and forth, Is this normal / Thanks

How do you remove snap ring on 48 Ford Car, the ring that holds grease seal n rear hub, Thanks

1948 how to remove snap ring on rear hub in front of grease seal;, Thanks

How do you get the snap ring out in front of grease seal in rear hub. Thanks

I'm replacing fitting on side of gas tank. How far should the line go through fitting into tank, thanks

Just what I was looking for at Third Gen Auto > Thanks for info will order right now.

Has anyone bought lug nuts from them for 48 ford car. I can't seem to get hold of them. Do the threads start in a ways on the nuts or start at edge ? Thanks Steve

Brian, the yoke coming out of rear end with open drivesalf

Mart, Which lock nuts.

V8COOPMAN What do you think is wrong ? Noticed grease seal was leaking

I have a 48 Ford that converted to open driveshaft. How much play up and down on the yoke, Thanks Steve

replaced bearing seal

This summer I have had to replace right rear grease seal 3 times on my 48 ford conv. What could be worn that would do this ? Fluid is down about 3/4" below fill plug. Also bearing seems to float back and forth a little bit. Thanks

I took the horn apart on my 48 ford and tipped the bowl of parts over and can't figure how it goes back together. Looking for detailed parts diagram. Thanks

What is a good 12 volt headlight bulb to use in my 48 ford ? Thanks

TO RALPH M, thanks for info. We were in North Pole, Alaska a couple of years ago. I believe that is where we went into a room that was -40 degrees with just tee shirts on. Kind of cold compared to Maine. Steve

I'm converting my 48 Ford to 12 volt. I found a reducer BWD VR1. It says it will handle up to 4 AMP. Is that large enough to run heater motor on high. Thanks