Search results

Does anyone know of anyone making axle retainers for 1928-31 Model A banjo rear ends? Not the ones from Speedway. I know it is not rocket science, but a nice, clean, well made and properly sized piece could easily be marketed through one of the vendors. This seems like an obvious safety item...

What is this e-brake? Not like the AR or like the later side mount. Warren

Is any one else using this combination, a nu-rex timing strip and a Yapp small diameter pulley. I installed these yesterday, set 0 or TDC using the pin and my timing marks do not agree. The pully is premarked for 20 degrees retard and 30 degrees advanced. When the motor is at 0 by the pin, the 0...

I had a clamp on wiper mounted to the top of the windshield in my 1931 RPU. Since I installed the new top, the wooden header as part of the bow assembly precludes me from having this wiper. I would like to install an electric wiper, I am willing to drill the frame, but the wood in front of the...

I took my 31 RPU out for a nice run the other night. This block has 6.1 head, insert bearings and a down draft. When I started out my REX-A-CO gauge pegged at 6. By the time I got home, the needle was barely floating. I was running Brad Penn green oil. The next morning I did an oil change...

1931 RPU Has anyone ever mounter a manual wiper to the bottom of the windshield? My windshield frame is not drilled for a wiper and I have been using a manual clamp on at the top of the windshield. Now I am installing a top and this means I must remove the wiper. I could drill the lower...

1931 model A RPU The release button on the top of the emergency brake lever is very heavy to push. I want to replace the spring with a lighter weight spring. I see the spring for sale for the 28-29 lever but not for the 30-31. Can this spring be removed and if so how do you get it out? Thank...

On my 1931 Model A, I have a Model FM horn that has two wires going through an access hole to be attached inside. I thought I had marked every wire location but I cannot figure out how to attach these wires to the armature. Please, help. Thank you Warren

I had to remove the e brake cross shaft. The bearings were seized on the shaft. I finally got things loosened up and the arms off the ends. I cleaned up the shaft and arms, the bearings slide on smoothly and before I order new bearings, I decided to test mount everything. I now have about...