Search results

I have a large logo 97 that looks like it has been rebuilt sometime in the past due to how clean it is and it looks like it has been yellow dichromate refinished. However, upon disassembly I noticed that the bottom part of the venturis where it slides into the cast iron base has corroded at...

My questions are about the comparison between the 9" and the 9-1/2" clutches The 9" clutch is just the typical clutch that was used for many years that used a standard Long style pressure plate. See the link...

Does anyone know a current good part number for 3-5/16" Piston Rings (0.125" oversized) for the ~42-48 pistons. I have a set of aftermarket three ring pistons that uses the older ring package that was the same on the factory Ford pistons in 42-48. I need a set of rings where it has 3/32" top...

Ford Flathead V8 3-5/16" Piston Rings 3/32" top rings 5/32 Oil Ring

59A Flathead that was built by someone else. This is what I was told that engine is internally: 276 ci Isky 400 Jr cam. It has a bit of a rough idle so it seems like it is a 400jr cam or least something comparable since I can't verify the cam without going into the engine. This is what I can...

Is the tractor starter the same as the automobile starter? From pictures, they appear to be the same starter motor. If the starter motor is the same, then is the Bendix the same also? The reason I ask is you can still buy new starters for tractors in your choice of 6V or 12V.

Is there an easy way to tell the difference between the 32/33 motors and the later 34-37 21 stud motors? Did all 21 stud motors have water pumps in the heads? Which 21 stud motors came with aluminum heads and which 21 stud motors came with cast iron heads(was this early vs. late)?

Was there a particular application for the mechanical advance limits for the 40B (16 deg. of advance @ 2500 rpm) vs. the 11a (24 deg. of advance @ 2500 rpm)? Was the 40B the very first one, say in 32-up a few years and then switched to 11a in the later 1930's. Also, was this at all related to...

Does anyone have any pictures of the markings on a genuine Isky Flathead V8 cam? I was trying to determine if a cam is a reground copy by someone else or if it was a cam originally done by Isky. So far, I have only found a picture of a new cam that I am pretty sure is a genuine Isky that had...

Looking for the specs on these two cam M-6 & M-14. I imagine the M-6 is barely better than a stock cam when the M-8 is 0.328 lift and 230 Adv. Duration. Also would like the know the duration at 0.050 duration for both cams, if anyone has that info also. Thanks, Roger

Anybody know what these were used for as in application wise to look up something similar that is new? The ground electrode is inside the steel shell, not in the usual location welded to bottom flat of the threaded section. Identical to this K-3 in the picture where they were being using in a...