Search results

40 Ford 16” wheels 5x5 1/2”. Need 4. Please state tire size if you have some. Ship to Lewiston NY.

Need a good quality bumper. Doesn’t have to be chromed. Correct mounting hardware also needed. Ship to Lewiston NY.

My ‘47 59AB is out for a rebuild and I received some photos of the bottom end. My engine builder has never seen this type of bearing use. Looks like main bearings used as rod bearings. Ha anyone seen this type of install before?

I am working toward removing the body from the frame and have been looking for bolts holding the body to the frame. Since I have already removed the entire floor, the only points I cannot be sure of are those starting at the rear seat kick up working rearward to the trunk. How many should I be...

I'm looking at a substantial rust repair cycle and need some advice as to where to start. 1940 Ford Tudor - rusted floor, rusted rockers and rusted through A and B pillars. So, where to start? My logic says start with rockers and build from there. Question is, how much to remove at a time and...

Gentlemen - I have finally pulled the motor and trans from my 40 tudor and would like some input as the engine's credentials. I have posted some photos below (don't know how to rotate them, sorry) and ask: Is this a 40 motor with later parts added, or is it a later model in an older car. Someone...

I own a 1940 Ford tudor with a C59A motor. On the Clutch side of the block, there is a “cup” that accepts the starter shaft as it engages the flywheel. Is this “cup” available as a separate part? Mine has been worn through in the area closest to the ground (likely from too many unpaved...

I am considering a few options to boost the power to my 1940 Ford sedan. How much power can the frame safely sustain before you should box it? I think that the most I would consider is approx. 300hp, with a 4 speed auto trans and 3.73 gears.