Search results

Can anyone point me in the right direction to a repair shop in north eastern PA that is really good with Flathead fords.. I can not find the issue with my 36. Runs great for about 1/2 an hour. Then is starts missing a losing power. I have replaced or repaired. carb Coil Distributor Fuel pump...

Ran my stock 36 for about 2 hours today. It ran great except for the last 20 minutes. The car stated to loss power and buck. It only did this under load. The tempter of the car was fine at 185. So i do not think it was vapor lock. The distributor was rebuilt last year and the coil was checked at...

Does anyone have a photo of the fuse holder that goes on the hot wire to the radio. Also does anyone know were to get one.

I have a 36 Ford convertible with the hart shaped wiper motor does anyone have a photo or diagram on all the parts to install in the windshield frame

Can anyone tell me were the best please to have a 36 Ford glove box clock fixed. Thank you

I am looking for a 36 car door hinge mirror. I would like to find a set of straight arm rather then the curved type. I see sets listed in some of the big part supplier sites but they say the are for pickups. Does anyone know if pickup hinges are different size then cars and if they are does...

What does the B5 stamped into the top of the radator tank stand for

Before I start this project I thought I would ask. So here goes The two arms under the dash the go from the cowl leaver to the cowl vent it self have broken. There is a privet pont were the lowered arm are contacted to upper arms. It looks like the were connected by a rivet. It is the rivets on...

I am adjusting my 3rd brush on my 36 ford. I what to find out how many amps the generator is putting out. Were should the multimeter be attached to and what should the reading be at idle.

Looking for a 35 to 36 straight arm outside mirror for a car. I would like to find an original please let me know if you have one to part with thank you

On start up the pressure reading in my car is perfect. Idle at about 15 running when hot around 25PSI. I checked with a oil pressure gauge. But some time after the car warms up the oriaganl gauge starts to push to the top at about 50. When I come to a idle drops back to around 20. Any thought of...

I thought that I would post this if there is anyone in the area that would like to go. Sunday April 24th at the Leesport Farmers Market Leesport PA

I have 2 different manufactures after market nos thermostat one opens at 180 the other 175. Is it ok to use the in together in my 36 ford

A have 2 barrel type thermostats for use in a 36 ford. I teasted them in water. One has a tight seal and opened up at about 175. The other does not seem to close tight and fully opened at about 165. Am I right to say that the thermostat that does not close tight and is not good.

I have a set of 32 wheels. My new understanding from the v8 times is that an option for the 36 was Larger 32 style wheels. My 36 has 39 juice breaks. So what hub can I change to so I can run the 18" 32 wheels. Also does anyone have the larger tire and wheel set up on there 36. Jacob

I'm looking for the following v8 times #1 & 2 July-August (7-8), 2012 #3 3-4, 2013 #4 5-6, 2013 #5 7-8, 2013 #6 9-10, 2013 #7 3-4, 2014 #8 5-6, 2014 #9 9-10, 2014 Let me know if you want to part with them Thank you Jacob

I now that there have been countless threads on this subject but I just not sure I am getting it. My tire are wide white on one side made by General the following is everything that is marked on the tire general 6.00-16. Nylon4 ply eyk047181. Pat no 2964083 Cl 3976 2

On my rebuilt steering box the shaft the pitman arm goes on to does not have a hole in it for a cotter pin. Has any one run into this before. I know i can drill a hole into the shaft but is there another way

I wired up my fog lights on my 36 ford using a 6 volt VW relay. I used the attached wiring diagram. The light work great. https://www.fordbarn.com/attachments/245868/ Issue is that my genorator does not keep up when the spot lights are on. Before I installed the fog lights when driving the...

What did the on and off switch look like for the 36 fog lights and we're was it to be installed. Thank you Jacob