Search results

I have been looking at the wiring diagram for my 1929 coupe. I think I would like to isolate the different components with fuses so if a tail light shorts out it will not burn out the 30amp fuse I have mounted on top of the starter. Anyone tried this out with success? What kind of fuse used...

Looking for 90 degree oil filter adapter

I have a nice running 29 coupe with a Nu Rex modern points plate, points, and condenser. Going on a 40 mile run New Years Day so I went to Adv parts store and bought a set of points for a 1970 Ford V8, the didn't fit right. They seemed to be to bulky and were hard to adjust, any body else have...

Looking for a Ford Racing 90 Oil Filter adapter

29 water neck with fitting for temp gage

Any body ever drill and tap a water 29 neck for an aftermarket temp gage sending unit? Is how well did it work and what part of neck tapped and details like gage used.

Wanted, a 29 upper neck with temp gage fitting.

I have installed "Mike's Affordable Oil Filter" kit on my 29 coupe engine. Nice setup except I want to rotate it 90 degrees downward. Have been looking for the Ford Racing unit which should work good but can't find one. Anyone use the remote kit that they sell that you can mount away form the...

Looking for the ford 90 degree oil filter adapter for my 1929 Coupe. I already installed the "Mikes Oil Filter side cover" but want the filter to point down with the Ford oil filter adapter.

Looking for a throttle arm and gasket kit for a model B carb

I converted to a 12 volt alternator and settled for 2 gauge cables instead of 1 gauge. 2 gauge were available in a lot of stores so I changed out battery cables to 2 gauge. I was in Tractor Supply yesterday and they have all kinds of 1 gauge battery cables and other tractor parts that will fit...

How do you install the new style bendix on the 29-31 starter? Anyone have a picture of the process. I converted to 12 Volt and a week later sheared the Bendix bolt on the old style.

I converted my 29 coupe to 12 alt, 60amp, neg ground. I would like to replace the battery cable to the starter with 2 gauge cable instead of the 1 gauge cable that ford used for the 6 volt system? Will the amp draw to the starter be too much for the 2 gauge cable verses the 1 gauge cable...

Do any of the major engine rebuilders keep a listing of the engines they rebuild? I have a mid 30 engine that looks like the babbits are not that old, would like to know what else they did to it.

What insurance companies are you guys using for your Model As? I'm looking for my vintage driver 1929 Coupe

I bought a 1929 Coups about a month ago. It has a lot of the original parts on it. Looking at the zenith carb the upper body it is marked with an "Z" but the bottom half has no markings. All of the Zeniths I have had over the years always had Zenith 1, 2 or 3 marked on the lower half. It uses...

What way do I attach my oil filter so it will be mounted downward instead of sideways using Mike's oil filter cover kit?

looking for a remote oil filter mount to change my side mount on the valve cover to an upright position, I think it is used on Ford engines.

Looking For one of the highboy air cleaners sold by Red Quail, Snyder's, etc.

Anyone know if there is any problem running Zenith carb with the inside filter screen removed? Just screen removed threaded fitting installed.