Search results

Anyone have P/N 51-2786? It's the small, toothed pawl at the bottom of the parking brake handle. 1950 F5 COE I will buy a complete parking brake handle if it comes to that.

Anyone have P/N 51-2786? It's the small, toothed pawl at the bottom of the parking brake handle. 1950 F5 COE I will buy a complete parking brake handle if it comes to that. Duh! this should be in the wanted section

We have probably all done it. You take something apart for for repair or refurbishment and then set an important small part in a "safe" place so you will never lose it......never to be seen again! I confess. I have misplaced a small part to my 50' F5 COE parking brake hand lever. Its the...

I am back working on my 50' F5 COE after a few years hiatus. Can anyone provide me diagrams and or photos of the the parking brake assembly and linkage. The factory manual is not particularly clear to me. I have all the parts cleaned and prepared for reassembly. Thanks

Can anyone tell me where part# 7539 rubber washer is located on or near the clutch equilizer shaft? I’ve seen in the parts drawings but don’t remember how it is installed. Thanks!

Need a pair of good used rear axles for a 31 A. Anyone in NW Washington state have some?

I have disassembled the rear wheels, drums and hubs off my friends Dad's 31 A Coupe after finding the right rear wheel had been damaged from loose lug nuts. I had to die grind the lug nuts off as the studs had spun in the hubs/drums. The right wheel, drum and hub are ruined. Upon inspection of...

Anyone have a suggestion of where or from whom I might be able to acquire a replacement Holley 1904 (list #1155) throttle shaft or usable throttle body? I have this carb on a 1953 6 cylinder 215 engine. I found the original shaft cracked at one of the throttle plate screws.

Just found a 56 F250 with a 215 6 cyl. that I believe is a replacment engine. Has power steering been added to this combination succesfully by anyone. I do know of the Toyota swap. Just curious if there was anything else to consider.Even with as large of steering wheel as it has it can be tough...

Did a 53' F250 w/215 I-6 have a factory fan shroud? Engine does not run hot. I like the added saftey of a shroud though.

I am looking for some help for my F5 brake system. I have searched this site and others for some time but have not come up with a good solution. Presently my truck has all stock brakes in good shape. I haul gravel and stones with this truck for my own use and regularly scale out a little...

I'm looking for the elusive 48' to 50' COE battery cover. I would even rent(?) one to pattern off of.

hello folks, I have a stock 8ba with the original generator in a F5 COE. I have purchased a Delco cs130 6 volt positive grnd 50 amp alternator with a 3 X 9/16th inch pulley to replace the generator. Can anyone give me an idea of what length vee belt I may need for this change. I prefer a...

I would like to change out the stock exhaust to headers ( tube or cast ) and dual pipes on my F5 dump truck. The motor is stock 8BA. I have a set of 2 inch outlet tube headers and am considering Brockmans or Porters. This truck is geared low for hauling. Any suggestions as to what size pipe...