Search results

looking for a pair of good tight 62 ford hood hinges or info on who can rebuild them.. any help would be appreciated. thanks

offering a fresh rebuild original "G" code galaxie. this was 1 of the nicest bodies to start with ,with only a quarter size spot of rust on the bottom of the right front fender. taken to bare metal and finished in raven black, with all correct black xl interior. all stainless polished and...

looking for 2 headliner bow extensions for a 62 galaxie 2dr. these slip on the end of the 2 rear bows and then hook into the side roof rails. look alittle like plug wire clips. thanks lin 757 342-0622:)

looking for some headlight bezels for my 62 ford galaxie. any help would be appreciated. thanks :)

looking for a 49-50 steering wheel. thanks

looking for a dipstick and tube for an early fe engine. thanks

have lots of y/block parts. blocks, cranks , heads, flywheels,pistons, rods, 272 040 over engine , rebuilt and on stand. cheap prices. prefer calls 757 342-0622 lin as i dont fet on the computer every day. thanks:)

down to the nitty gritty of finishing my 406, and am in need of an adjuster. any ideas where i can find one or (?) hate to buy a complete set but......any ideas would be appreciated. thanks

getting ready to assemble my 406 heads and in looking thru my head parts i found some cups. cant find any info in my shop book, so i thought i would ask the experts out there. using a comp cam with corresponding springs, so do i need to use these cups or discard. thanks

have a 272 block 040 over on engine stand. new bearings on 010,010 crank.new rings,timing set. never run. comes with set of 56 'c' heads in napa bags, oil pan timing cover. should have most everything except int manifold. ready to inspect and install heads etc. pm if interested.

anyone have any of the old button cam parts? spring , button ,etc. should consist of spring, bolt, button, retainer and fuel pump eccentric. thanks

looking for 2 C2AEB connecting rods. these have 7/16ths rod bolts. call lin @ 757 342-0622 thanks

anyone have any specs on the pushrod that was used in a 62 406 engine? need to order some and do not have a used one to give them the specs. appreciate any info or where i may get a set. thanks

have a set of used ford 406 .030 over flattop pistons. my block is going to require a .060 bore so maybe someone can use these. good condition with pins. lin @ 757 342-0622 thanks trades considered.

selling some y/block parts such as a 272 040 over shortblock, still on stand. 150.00 292 with 080 jahns pistons this too is a shortblock on stand. 275.00 nice set of "b" heads still in napa plastic. 125.00 a 292 shortblock, originial with 2 stuck pistons in block, stock 75.00 truck oil pan...

looking for some 62 ford 406 parts,specifically generator and brackets, clutch linkage, drive shaft or drive shaft yokes or part #s. thanks . :):):)

have an aluminum bellhousing with the #s RFD50P-7976-BAE anyone ID this for me? thanks

have an aluminum bellhousing with the #s rfd50p-7976-bae . bought it for a big block c4 hookup, but never used. not sure of its use. anyone have a parts book and help me identify this? thanks

looking for an old centerline aluminum 15x4(?) ford front runner. needed to complete wheel setup on an old 57 ford drag car. email at lstanworth@aol.com thanks