Search results

Where can I find six metal stem tubes for 19inch tires?

Does anyone have an old torque tube flange I could purchase to press in a pinion assembly? Picture below I borrowed from Tom Endy.

Has anyone tried to install a regular Mitchell Overdrive in a 30-31 Victoria? I understand that on the Victoria's they move the gear box forward 4.5 inches to clear the floorboard. I have a regular Mitchell and want to put it in the Victoria. Is there any other way to do this without moving the...

I have a closed car and would like to check to see what the frame number is but I don't want to take the body off of the frame to do so. I know I am going to have to take the body loose from the frame but I don't want to be too invasive. I need to take the fenders and splash aprons off to paint...

On a 31 Victoria rear seat, is it supposed to hinge forward to reveal a small storage space? If so, are there supposed to be cutouts in the sides of the seat back so it will clear the armrests?

My horn blows just fine with car running or off. When I turn the lights on or hit the brake it just growls. Do I have a problem with my generator?

Is there any difference in the steering columns on a regular model A Ford and a Victoria? I know the Victoria is dropped about 1 3/8" at the steering column bracket on the gas tank , but is there any difference between the Victoria steering column and any other model a Ford steering column?

I have a Boyce motor meter made for a model A to mount on steering column. It has a sensor, that I was told mounts in a hollowed out head bolt. Is this correct? Could the head bolt still be torqued if it is hollow? Does anyone have one they would sell?

Silly Question: What is the.best way to determine the gear ratio in a rear end without taking it apart? Do you simply jack up one wheel and rotate a tire and count the number of turns of your wheel ompared to your drive shaft? If it is a 3.78 the drive shaft should turn 3.78 turns to the...

Would there be a problem using a Mitchell Overdrive with a Float-A-Motir set up? The thing I am concerned about would be the overdrive shifter would have to mount on top of ****** and the float-a-motor has a brace that mounts ahead of the cross member. Would they get in each other's way?

What would cause a coil to melt completely down? I was thinking maybe the ignition switch was left on? It got so hot the guts fell out. Thanks for any input.

Is it common knowledge that the stipe shocks are for 1928-30 with the small ears? They don't make them for the 31 models?

What is everyone's opinion on the best tire size for a Model A 19" tire? 4.75, 5.00, 5.50, etc. I guess if you have side mounts and use a large tire you would have to deflate to get it in the well and then inflate? A larger tire would give you a smoother ride. Getting ready to buy and wanted...

Are the side splash shields for the 31 Model A good or is there fitting problems with the front fenders? Thanks, 31 RPU

Does anyone have any good shocks, that need to be rebuilt, for sale? Also, who would you recommend to do the rebuild? Thanks for any help on this.

Can someone give me a link to the vender list. I can't seem to find it....? Thanks

Is there really any advantage to the later oil pump with the larger hole compared to the earlier pumps with the smaller hole? Does the larger hole allow more volume of oil to flow?

I don't mind a little side to side wobble but I don't like the up and down. How much is acceptable? I am going to have an overdrive so I want as little as possible but how much is too much? Has anyone tried to straighten?

Just got a set of brake shoes and they have the non woven linings on them and are glued with no rivets? Are these ok? An old timer told me that the woven are the best. I am using these with cast iron drums.

Has anyone tried an electronic ignition? Any pros and cans? Just wandering if that would be the best way to go.