Search results

What is the simpliest and easiest fuel filter to install on my 1933 model B ford?

How do I clean check and clean out my model b fuel pump for sediment?

Do you recommend a fuel filter for use on a model B ford or can I just try to keep the fuel pump , sump, clean?

Is there a good fuel additive that can help keep carb jets open?

Which of these carbs is more reliable and less likely to clog.

1933 model B Now that I finally got my car running again, idles fine, but engine stalls when step on accelerator. Could it be a fuel pump problem?

My son just bought a 2000 corvette and is looking for a quality outdoor car cover. Any suggestions

I am using Valvoline Daily Protection Non-Detergent SAE 30 Conventional Motor oil and just changed it and the old oil flowed out like water. Should I be using sae 40?

I have and analog multimeter and 2 digital multimeters. How do I electrically test a condenser? There only appears to be volts and amps on the meters not ohms? Even though I loved physics, I always hated electronics C = Q V

Model B 1933 Installed new starter Installed petronix ignition coil <flame thrower..RIGHT? Cleaned points What next? Can I electrically verify that the lower distributer plate is NOT shorted to the top plate? Continuity test with my multimeter. Where would i test from? Points to distributer case?

Where do you guys purchase these.

I am still having problems with my model B distributer. What do you think of the electronic ignition systems for a model B distributer? I would like to stay with the original, but if I cannot get it running I will consider anything to get the car running again.

WOW https://www.youtube.com/watch?v=vJ9lFl3H6SE

https://www.youtube.com/watch?v=aAAksidU9Yo

How do the rear ends of a model B and a v8 differ?

https://www.nurex.com/nu-rex-nu-wrench Does this tool work with Model B timing or only model A timing?

What skill level is required to perform this task

Can a model B 1932 starter be converted to a 1933/34 model b starter

1933 model b replaced coil and condenser When starter is activated car ammeter jiggles, but have no spark at plugs I am getting so old and confused, need help

i AM A lone repairman, a simple task like attempting to bolt a starter back into a car is a nightmare for a solo repairman. It would take one man to line the starter up with the holes and another person to screw the bolts in. If I could only get ONE bolt in then alignment with the other 2 holes...