Search results

Chrome vent fan has been re chromed and rewired with a modern fuse holder. Ran it in my 36 Ford and removed it before it was sold to install in the next car that never happened. $95.oo shipped to the lower 48 states.

1935 Fuel Oil gauge with oil sender. A repair was made on the sight glass tube I did fill the gauge with isopropyl alcohol and did not see any leaks. $90.00 shipped to the lower 48 states

I have a late 40s early 50s Sun Dist machine that I purchased in the 1970s the strobe is getting weak and will only flash at higher RPMs, every thing else works as it should. Suggestions for repair. Thanks Mike

Std. 09T pistons bead blasted with 8BA rods fitted with.005 oversized pins. were run for a short time had a bad block got another block but its .030 over so they are no longer needed. $90.00 + shipping.

Planning on doing a repair on my 1935 hydrostatic fuel gauge sender over this winter. Will the fuel soften the JB Weld if submerged in fuel tank has anyone used it for ruel system repairs ??

What do the little cups on the sender do the lower one is pretty much gone see photos. Suggestions for repair? Mike

The fuel gauge is pushing the red fluid out the top of the glass tube in to the gauge. I have removed the gauge and cleaned it more than once and cleaned the sending unit last year. suggestions Mike

Can anyone tell me what year this might fit doing spring garage cleaning or better known as moving parts from there to here. Mike

1935 sedan with a stock 59-AB using the 35 intake manifold. I have 3 cabs a 46-48 Ford 59 and a Stromberg 97 and a Stromberg 48. Not looking to go racing just a nice driver and best for fuel mileage as we like to do trips. I intend to rebuild one for the upcoming driving season.

Ford script starter solenoid used Tests OK with an ohm meter. $30.00 + shipping

1936 maybe 35 Cigar Lighter, came from a 36,000 mile 36 ford in bought in the 1960's. Tested the element with a DVOM and it has continuity the dash receptacle is in fair condition. the brown knob is from a reproduction set in purchased for my 35. $75.00 + shipping

1949-43 Mercury oil filter restrictor fitting $2000+ shipping

Columbia/SouthwindHeater carb vacuum plate good condition SOLD + shipping.

Ford #59 carb nice clean carb all the linkage intact, install a modern gas kit and it should be good to go. $85.00 + shipping.

Found this in the back of my tool box, I currently have a 35 Fordor i don't believe it is from my 35. Sugestions ???? Mike

One of last winters projects was the hydrostatic fuel gauge on our 35. I removed the gauge cleaned with acid water then isopropyl alcohol. Removed the sending unit blew cleaned it and blew out al the tubes with compressed air. I also blew out the gauge line while it was disconnected from the...

I have been doing flathead distributors for myself and Badger State club members since the mid 70s when I purchased a Sun tester from the Sun rep while working as a tech at a local Cadillac dealer. The other day a member brought his dist over for me to check, never seen a point conversion like...

I am running a Stromberg 48 on a stock 59-AB in my 35 using the 35 intake manifold. What would be the preferred jet size, all the jet's in my spare parts are 45's don't know what is in the carb know but planning to do a overhaul.

1936 Throttle rod yellow knob with black lettering $30.00 + shipping

I recall reading somewhere that in the 1930's when the standard cars only had one tail light some state mandated a right side light be installed. Does anyone recall which states they were ? THANKS' Mike