Search results

The car runs, but not the way it is supposed to! I contemplate the method I used to time the ignition and on what top dead center cylinder? (From the front of the car, which is the number one cylinder? I assume it is the forward most cylinder? Am I wrong?) I ordered and received...

I would like to know that if my clutch forks are worn out, would that cause the car to jerk/pulsate when in high gear going down the road? It just seems like the high gear is not fully engaging? If not, would there be something wrong with the rear end gears and/or bearings? I looked in both...

If you have been following my other threads, you will already know where this project began. If you are new to this project, then you are probably lost! Hopefully this site will allow me to sum it up into just pictures to give all of you the full story. I skipped a few photos during the process...

26 Ford Model T....How in the world do I adjust the trans and linkage to get absolute neutral? I am flabbergasted on this particular problem. How do I adjust the High/low pedal and the linkage to the brakes? I have no neutral even if I unhook the linkage! Is there a set screw on the side of the...

Last weekend I took the Model A to Swigart Museum in Huntington, Pa for a car show. I got second place!

26 T carb rebuild. I got a new kit for my holly NH carb and noticed there was a fiber washer that came with the kit. When I took the carb apart, I didn't have one come out of it! Can anyone explain it for me please? Thank you

What color is the "hot air pipe" (Some call it an evaporator pipe) from the carburetor to manifold supposed to be on a '26 T? NOT THE INTAKE MANIFOLD, THE HOT AIR PIPE!!!Thank you. Light Green? Gray? Engine Green? Black?

Getting ready to pull the '26 Model "T" Roadster in the garage. My dad says it needs new bands and new starter. The last time he restored it was 50 years ago with his dad. They only put about 400 miles on it....then it sat since 1991 'till now. Do you think I really need to replace the...

Put all new multiple disks in and throw-out bearing in...(going by my Dad's word). The car runs great going down the road, but every time you go to shift, seems like the throw-out bearing is not doing it's job? Right now there is no play in the clutch pedal/lever.... Is that a bad thing and...

I did it exactly the way the book says.... 3 times! I used the little pin in front on main crank. Lined it up Turned rotor cam to line up on no.1 in distributer. Turned it 180 degrees opposite like it says... Set the points and rotor cam to the exact specs from the book... Put it all back...

I have the wiring diagram right in front of me, but I want to know which side of the coil is plus & minus? It only says on one side "dist"! Is the "dist" side plus or minus? Thank you!

Rebuilt motor... new battery... put in time... cranks over... getting gas... NO Spark! Adjusted the points to manual specs... tested ohms from AMPERES gauge and it spiked! Should I start with a new AMPERES gauge? ...or Coil?

Just restored this Model A for the second time in 50 years since I've owned it. I made a huge mistake this time by putting the Transmission gears in backwards. Long story short.... I didn't noticed this problem until after I got the car all back together. Is there any way I can take the...