Search results

Other than the brake shoe cam holes round or 2 straight sides is there any difference in the shoes. my 47 has the round holes but catologs call for the straight holes thanks

Hi i can not get rear brake drums over the shoes. Drums cut .020 new drums new wheel cylinders emey brake not hooked up. I can get the drum on about half way. i've been told the shoes may be oversized and have to be cut down. That seems to be something done in the past. Can you by shoes that...

can a 1950 ford f 100 side shift open drive transmission fit a 1948 car. I know i must convert to open drive Thanks

What year did fordvf 100 go to column shift

What year did ford f 100 go to a column shift

What year did ford f 100 go to the column shift Thanks

Can a 1947 transmission be changed to open drive

Is a difference in size between a 4 door and a sedan coupe

Has anybody run in to fit problems with the metal scuff plates in a 1940 ford coupe from carpenter.

There is a metal channel in the rear of the front door that looks like it is welded in. 11A 7021572-A right side. It is broken and partly missing. This is the part where the channel you buy snaps in. Is there anybody who makes this part. I have 6 doors and this part is damaged or missing in them...

Hi 47 ford car with what appears to a bad clutch shatter. I have previously changed the clutch and machined the flywheel and changed the rear end seals.(Fort Wayne clutch). For the first year I couldn’t Make the clutch chatter. The second year the chatter came back almost overnight. I’m...

anybody know what happened to the Niagara swap meet this year at Lancaster. Not very many vendors or buyers. Didn't take 30 minutes to view the whole show.

i have a 1956 Ford with a stock rear end that is shot. I have a good 1957 Ford rear end. Will it bolt in the 56. Also will the 56 backing plates and drums fit the 57 Ford rear end as they are new. Thanks Bill

how do you know when the u joint cavity is full. If you put a tube of corn grease in it on assembly. And it is sealed properly and it doesn't leak why would you keep adding grease every once and a while. It has to go somewhere ( like a blown seal in the torque tube or are not adding to much...

are bumper wing tips the same for 1946-1948 or are 1946 different. Thanks

Can silicone be used for a transmission pan gasket on a Fordomatic. Thanks

Has anybody used a Bendtsen transmission adaptor in a 1956 Ford. Just wondering about clearance at firewall and floor. Thanks

how far does the gas line go into the gas tank. I have the sender out but i can,t see the gas line. The tank looks very clean but I wanted to check for rust on the gas line. Once the line goes in from the side it must then run down.i have run out of gas twice and I took out the sender and I had...

1947 Ford. On the passenger side head there is an alternator bracket installed with 3 head bolts. I want to remove the bracket to the center. I need to know the proper size of the head bolts because these could be longer because of the bracket. These are the top 3 bolts. Thanks for your help

On a 47 Ford Convertible Body mount #2 and # 3 by the front door are steel mounting blocks instead of rubber mounts. Just looking to see if anybody has any. Thanks Bill