Search results

I am not real pleased with how my 50 handles, my Model A actually is better. I have an older Jamco front suspension, had alignment done etc. What should I expect for drive-ability with this car? I also drive this car on the highway. Thanks, Steve

Hi All, Looking for some Model A shock cores. Anyone have anything? Thanks, Steve

Hi All, Looking for a 1950 Ford Passenger car driveshaft, or possible the joint that goes to the rear axle. Something close by would be great Thanks, Steve

Hi All, Does anyone know if H series 6 cyl engines and 8BA share the same flywheel? Thanks, Steve

Hi All, Has anyone installed a Snyders heater in their Model A? If so does it work well? Is the heater motor fairly quiet in operation? Thanks, Steve

Hi All, Looking for a 1950 Ford Truck 6-cyl Intermediate Bell Housing and probably starter plate. Thanks, Steve

Hi All, Looking for 49-50 steering column pieces that hold the bottom of the shift tube to the column tube (parts #7318 and #7319 in the Ford catalog). Thanks, Steve

Looking for a 1948 Ford Pickup. Good condition restored or unrestored. Thanks Steve

Hi All, Does anyone know if any of the 6 cylinder 49-51 cars came with or utilized overdrive transmissions? I need something that will allow me to drive my Shoebox on the highway? Another option I have been thinking is to install a 9" rear with 308's but wondering if i would lose all of my...

Hi All, Anyone have experience with Holley 1904 carb? Tried one on my H-226 flat 6, ran incredible then flooded out. Thanks, Steve

Anyone running one of these carbs on a 226-6cyl flathead? Anyone using this carburetor with success? I have had several and not a lot of success, stumbles on acceleration but runs well under power. Thanks, Steve

Anyone with a Shoebox 49-51 comment on how well your heating system works. I have a NOS Magic Air system in my 50 Tudor,it works ok but not great. Tell the truth the manifold heater in my Model A seems to put out better heat. Thanks, Steve

Hi All, Does anyone know what the rear gear ratio is in a 1951 coupe 6-cyl? Also, my 1950 ford Tudor does not seem to have a hole in the firewall for the heater blower wire. I've looked everywhere. Any thoughts? Thanks, Steve

Looking for a good 30/31 Model A frame. North Shore MA or Southern NH would be ideal but open to options.

Hi All, On the 226 6-cyl does the coolant flow from the water pump fitting to the heater control on the firewall or from the cylinder head to the heater control on the firewall? Green bible is not clear on this. Thanks, Steve

Hi All, I am installing new door locks in my Tudor, I have them mounted and the square rod is inserted into the square hole in the door. What/how are they connected to the door lock mechanism? Get the feeling that I may be missing some parts. Also, how are they connected to the door lock...

Hi All, Looking for a good set of 1939 Ford brake and clutch pedals. Complete unit. Thanks, Steve

Hi All, Question: The timing cover on my Ford 226 engine has 2 pointers coming out of the timing cover. Which is the correct pointer to line the timing mark on the harmonic balancer when using the timing light to set the time. Thanks, Steve

Hi All, Looking for the breather tube that sits in the tappet valley between the block and intake manifold, this in the front part of the engine. These are unique to the 49-50 Ford and Mercury. Thanks, Steve

Hi, Thanks for getting back with me. Amazingly I located one close by, couple miles down the road. All set Regards, Steve