Search results

Ford Barn members, I would appreciate your help to locate someone who works on returning '35 horns to working order. Mine quit working this spring and I only get a little "honk" after many attempts occasionally. I am looking for someone to diagnose the issue, repair, and allow me to have a...

Ford Barn members, I would greatly appreciate your experience and input on an issue I had this morning when waking up the '35 Tudor Touring Sedan from winter sleep. After running the engine just over 10 minutes at or slightly above idle to mix up the new coolant, I noticed the amp gauge was...

Ford Barn, We discovered during '35 Tudor Touring Sedan restoration that my running board trim strips (mouldings) were not for a '35. I had them polished before figured that out. I would appreciate input on if the strips, which are 59" long and 1" in height, are these for a '37? Many thanks...

Ford Barn team, I have a basic question regarding recommendation for wheel bearing grease as I need to reassemble rear drums on '33 pickup and would like to use the correct grease. Recommendations requested. Thanks in advance, Steve Keep V-8ing

Ford Barn members, I have a "shout out" for the great job that Ralph the Radio Guy did repairing my 1935 Ford Philco FT-6 radio and head. He did a great job bringing the damaged radio back to fully functional. In addition, a chip was added to allow me reception of both AM and FM using the AM...

Ford Barn members, I bring you a basic question for assembly of 33/34 rear drum hub components: bearing, grease seal, and snap ring - do you have a diagram or a couple pics showing order of assembly and how far the grease seal should be driven in? I appreciate the help. Thank you Steve

Ford Barn members: I'm interested in a new FH-2V flexible fuel hose with integral check valve for 32-48 Ford which Bob Shewman manufactured. Does anyone have a spare that they would be interested to sell? Please let me know. Thank you. Steve

Ford Barn members, I am interested in your recommendations for a coolant to use with aluminum heads that I can leave in the system through the Michigan winter but not encourage reactions with the aluminum. I have been using No-Rosion with water and draining each Fall. However, I had a great...

Ford Barn Members, We could really use your help: How do you go about replacing the drum lug nut studs on an original '33-'34 Ford rear drum? Are those pressed in? Machine shop job? Concerned that the casting may not be able to take the force of pressing out the old and pressing in the new...

Ford Barn members, We are preparing to swap the transmission out in our '33 pickup. Would you consider replacing the clutch (with about 2100 miles on it) at the same time? If so, what kind of clutch would you recommend? I heard about a newer style but admittedly not familiar with it. Thanks...

Ford Barn members, I have a few questions which are a bit basic but would appreciate your help to make sure get this right: 1. Transmission: a. '37 case, is the required volume 2.5 pts or __? b. Full when just below the fill plug hole on side of case? c. 600W oil, correct? 2. Differential...

Ford Barn members, I am trying to get my '35 fuel gauge functional once again. I have found a company in SC who can clean it. Also found a source for the red fluid from Renner's Corner. I would appreciate guidance on how to add the right amount of red fluid and calibrate the gauge. My Dad...