Search results

  1. C

    Need 13/32" socket for the GAV housing.

    Did a search and didn't find a thread. Remember a few years ago a thread that someone was furnishing them. Anyone have a source for one? New or used. Thank you in advance. Charley
  2. C

    Simmons carburetor idle jet question

    Can someone verify the thread size on a Simmons idle jet? The thread size on a Zenith idle jet is M5x.75 metric. Other than the thread size possibly different. Is there any other difference in the idle jet compared to a Zenith? Thanks in advance Charley
  3. C

    Brass adjustment needle question please

    One of my gas adjustment needles has two small holes at and near the tip. All the others are solid. What is the application for the one with the holes? Thanks in advance Charley
  4. C

    1931 Budd cab black door panels and fasteners

    Is there a source for the two black door panels and fasteners for a 1931 Bud cab? Thanks in advance Charley
  5. C

    1931 wide bed tail light bracket photo needed.

    Hi Could someone please post a photo of the factory wide bed pick up tail light bracket? Thanks in advance. Charley
  6. C

    For Sale 1958:Ford Fairlane 500

    1958 Ford Fairlane 500 2 door coupe. Palomino Tan with 54,300 miles. Automatic transmission with 332 V-8 engine. Excellent original floors and trunk. New: Ball joints, tie rods, and front end alignment. Exhaust, master cylinder, brakes. Gas tank and fuel pump. Tires, carpet...
  7. C

    1931 coupe factory roll down rear window and trunk question.

    Just curious, does anyone have a 1931 coupe, standard or deluxe, with a factory roll down rear window and trunk? Thanks in advance Charley
  8. C

    Original motor value

    Just curious. Would a Model A with the original motor be valued higher than a replacement or restamped motor? Also would a replacement or restamped motor give you pause not to buy the car? Thanks for your opinion Charley
  9. C

    Delete

    Need one to four new Champion #34 spark plugs. In the states only please. Thanks Charley
  10. C

    Delete

    Need one to four new Champion #34 spark plugs. In the states only please. Thanks Charley
  11. C

    Oil pressure and water pipe question

    My friend that recently purchased the 1928 Phaeton has a few more questions. He'd like some advice on. There was an oil filter added to the engine. There is an oil pressure gauge mounted below the intake manifold. It reads 2 lbs with motor running. Thoughts on this? Also there is a tapped...
  12. C

    Remove sludge from bottom of gas tank

    A friend recently purchased a 1928 Phaeton. The car had been sitting three years. The fuel bowl was removed from the tank and fuel drained. That left about 1" of sludge on the bottom. Ideas to remove sludge without removing tank? Thanks in advance Charley
  13. C

    Wanted: Three spoke generator pulley.

    Need a long nose three spoke generator pulley and a good cut-out Thanks in advance. Charley
  14. C

    Wanted right front fender 1958 Ford Fairlane

    Need excellent right front fender for a 1958 Ford Fairlane. Ohio area preferred for pick up. Other areas if you can ship via Fastenal. Please PM. Thanks Charley
  15. C

    Sparking at starter switch

    Yesterday we drove the 1931 pickup. Started four or five times without any issues. Last night when I attempted to start the vehicle to put in the garage. While holding the starting foot pedal down I only got some arcs below where the foot pedal rod connects to the starter switch. Removed the...
  16. C

    Rear axle change 1931 ccpu

    We have a 1931 ccpu. I'm sure the rear end is a 4:11. Top speed in the truck is about 35 or so with the engine racing quite high. A friend has a spare rear end we determined to be 3:78. Would this rear end get me to about 40 to 45 without the engine racing? There is mention of a 3:54. Is this...
  17. C

    Wtd Herbrand HT-660 coil tester

    Would like to purchase an operable Herbrand Ht-660 Coil Tester. Thanks in advance Charley
  18. C

    Wtd Herbrand HT-660 coil tester

    Would like to purchase an operable Herbrand Ht-660 Coil Tester. Thanks in advance Charley
  19. C

    Herbrand Ht-660 Coil Tester

    Would like to purchase an operable Herbrand Ht-660 Coil Tester. Thanks in advance Charley
  20. C

    How to determine gear ratio on rear end out of vehicle?

    Have a 1931 ccpu with a low gear ratio probably stock. My friend has three spare rear end assemblies. How would we determine the gear ratio of these units? What ratio would I want to use to get a little more top speed out of the stock motor? Thanks in advance. Charley
Back
Top