Search results

Free to a good home, shipping included, first reply gets it. GONE.

I will put these in the mail tomorrow or Friday to the first person to IM me their name, complete address.

Listing for a friend, contact information below. Pictures on HAMB https://www.jalopyjournal.com/forum/threads/1929-av8-roadster-pickup.1264926/ 1929 Ford AV8 Roadster P/U 50's Syle Build 51 Ford 239 cu.in.V8 Twin 94 carbs on Fenton Intake New Speedway water pumps New Walker Radiator New...

Leftover Ford Wood for 30-31 Roadster, 1502 (all 5 pieces), 1507, 1508, 1509. $75.00 includes shipping.

Wide belt pulley, includes shipping $50.00

Oil pan, two dip sticks, $125 includes shipping.

AV8 Roadster Project on HAMB. Chevy distributor and carb/manifold set up by Charlie NY. KIWI L100 cam by Tony https://www.jalopyjournal.com/forum/threads/1930-31-av8-roadster-project.1240914/

AV8 Roadster project on HAMB https://www.jalopyjournal.com/forum/threads/30-31-av8-roadster-project.1237724/

How do I remove trunk handle lock cylinder? Thank you.

Are the camshaft lock ring bolts a specialty item (340500-SK from Van Pelt) or can I buy at hardware store? If so what size? For 8ba engine, thank you.

Trying to install cam into block, cam is a Kiwi 100 from Tony. Cam bearings were installed at machine shop. Did not have cam when bearings were installed. Oiled bearings and journals for test fit. The cam would not slide in. The journals measures 1.797 and the cam bearing measures 1.794. I...

Which way does this headlight bar go on 30-31? Thank you.

Are these guides reusable with the gouge on end? Was going to have Gofast put bronze liner in them. Thank you.

Front Arm Rest A-56665-PR Drake includes shipping. $35.00.

After obtaining 5 49-53 blocks I finally go a good one. Along the way I've accumulated parts I do not need or want laying around. Are any of these worth trying to sell, give away or just scrap? They are all stock, unaltered, except for the one crankshaft. Thank you for your assistance. 1...

Getting desperate, have taken 4 8BA blocks to machine shop, all four had cracks too deep to fix. There is a block with .080 bore on ebay within reasonable driving distance. My question is .080 too much...

Sold

3 speed manual transmission from '51 Ford $75.00.

I would like to take this heater apart, clean up the rust and paint. If I drill the rivets out what would I need to replace them? Is there a process, special tool, use substitute method to put it back together? Thank you for you assistance.

49-53 with gouge by value seat, machine shop says it junk, head gasket won't seal, oil pump rusted on, come and get it other wise it's off to the scrap yard. 2nd block available, cleaned, 2nd machine shop says not repairable, crack too deep in cyclinder