Search results

Wheels need some work - some pitted - still solid - good project - can send picks - near Charlotte, nc

Five solid 21" wheels, with some pitting-one not true but a good spare- in a barn for 48 years. Will trade for five good tubes. TD

Need some nice used tubes for my 21" inch tires.Will trade 5 wheels for tubes - email me

Pulled the old girl out yesterday and took her for a stroll. Ran clean, smooth, went threw the gears with ease. Proud moment. No tires on her so we didn't go far. 4 times out without a hitch. Just share'n! TD

any suggestions on the best way to remove the zinc plug at the top of a 29 steering column? Mine is really in there! TD

With the car show in a few days I hope "A" vendors have listed their spots on the Barn- if not here's your chance to. There are maps on the meet's site where you can mark the locations. It'll save a lot of walking TD

Just thought I'd share a photo with you guys. As you can see it takes a whole family to raise an "A" from the edge of doom!

Anyone know if there are pull carts to carry fold out chairs and supplies at the meet. TD

Well, after many hours of matriculate cleaning, part replacing, gauging, scrounging parts, bartering and measuring the old gal fired up this weekend and runs like a charm. She sat for 49 years, all toll, waiting for this chance to bark once more. I started her with the hand crank as did my son...

I have a Model T wheel with a mounted tire - its in good shape - never been on the road - it was in the back seat of my A when I bought it. TD

Here's some pictures of the rear floor panel behind the drivers seat of my 29 town sedan. I think it actually had a heat vent for the rear passengers. I assume a hose from somewhere. Is this factory? Any one know if there is a replacement available? TD

any one know the procedure to press out a hub on a front drum and press in a new one? TD

anyone have a diagram or picture of the routing for the speedometer cable. Also the bolt hole for the clamp on the frame. Wish I'd taken a picture when I took it off! TD

I'm installing the wishbone to the trans housing. The car had a replacement rubber insert in a large cast housing. I purchased the original which is thinner and has two sides and relies on spring tension and lubrication. I cannot find any good pictures of this and would appreciate any advise. TD

Just finished my front brakes and discovered a front drum is no good. Hoping to find a replacement.

I have 5 - 19" black tires that are new. Still have stickers on the tread. Stored inside for 10 years. They are in very good condition. I can't use them and I need 21" tires to put my 29 on the ground. Will swap for 5 used ones with decent tread. My pictures wont upload so email me if you'd like...

I have 5- 19" tires, black wall, stored inside for 10 years. Still have the stickers on tread. Not mint because of age, but very nice. Will trade even "steven" for 5- 21" just OK tires. Pictures wont up load so I can email them to you. Basically 5 clean black tires with stickers on tread, red...

Does anyone have some good pictures of rear brakes from behind the backing plate. I would like to know if my levers are correct. Any pic's of the main pads before the parking band assembly is attached would be also great. Don't want to feel that working ALL Day on them was for nothing! TD

Thought I'd drop a couple of picks of the old girl as she comes to life. Hope all the hard work and high level of correctness is screaming back at ya. It's hard not to spend more time on her! TD

Sorry - this is a double post