Search results

Looking for a glove box liner for a 39 convertible. Nothing available from parts companies. LMK what you got. Thanks.

See post below. Sorry double posted.

How does the rumble seat attach on a 34 roadster? I have these brackets, but not sure how it goes together as it was apart when I got it. Here's pics of what I have.

I'm trying to figure out where the spring for the brake pedal attaches. Its attached to the pedal, but where does the other end attach at? Pics or a good explanation would be appreciated. I'm just not seeing anywhere it attaches to. It's on a 34 Phaeton. Thanks. Bob

Trying to find out the length and diameter of the two rods that go to the top part of the hood(not the side rods that connect the side hood and top hood). They go thru the piano hinge and attach at the radiator and cowl. Also how is the stainless trim piece that goes down the center attached...

Does anyone make the stainless steel trim ring that goes around the spare tire cover on a continental kit? I believe it's the same for all 34 fords. Thanks, Bob L.

Where can I get new housings for the interior lights that go on the B pillar? The wires are bad on mine.

Looking for the dash trim that goes around the radio speaker on the dash for a 1938 standard. Thanks

Went to start my car this summer and all I got was a buzz then nothing. Checked and cleaned all my terminals. Nothing. Replaced my solenoid, nothing, could get it to click at the solenoid but not at the starter. Had my starter rebuilt, put it back in and nothing still. I know it's not the...

Looking for where I can buy the engine block petcock used to drain the block. One for each side. Haven't been able to find anyone that sells them.

I'm looking for a diagram on the 1938 Ford standard hood ornament that shows the parts that make up the assembly of the hood ornament. Any pics would be greatly appreciated.

I have a new set of D. Carpenter Floorboards for a 1938 ford. Never were installed. Actual shipping on your dime.

Looking for a gas filler neck for a 1938 ford standard sedan. The ones they sell at Carpenters and Drakes are not the right size. Too long and the bend is not right. Must be standard and deluxe models were different.

I am going from cast iron heads to aluminum heads. I noticed that when pulling the heads there was silicon on the stud holes. Should I put rtv on the studs to prevent leaking? Anything else I need to do special besides the difference in torque settings that I need to do? This is a 60hp flathead.

Am I right in assuming that you soak the front rope seal(for engine) in oil for a day before putting it in the waterpump housing plate and cutting it to fit?

I can't get the waterpump to seat against the outer gasket. I rebuilt the pump and replaced the rubber inner seal. I don't know why this won't tighten up. See attached photo. Image I have cleaned the housing and even have tried a nos pump with the same result. Any suggestions would be...

Looking for water pumps for 38-40 60hp flathead. Also the waterpump housing. Bob L. (616)642-0701

Looking for door stainless for a 38 standard Tudor.

Looking for the two plates that attach to the driver's side toe board. One goes over the pedal holes and the other holds the e brake cable down.

Looking for someone I can converse with who owns a 38 Tudor stock or close to it. I have several questions on putting this car back together and need some answers that I don't find in manuals. Would really appreciate it. Bob L.