Search results

Any ideas what might be causing this? I have the stop the right way through the axle at the spindle with the correct nut. Only thing I noticed there is no lock washer on it? Also it is a full turn and a bit to right stop but at left it is a full turn and a quarter to stop. Thanks

Looking for a good original ammeter to ship to Canada.

Hi All, Just wondering if some of you might have the answer. A friend just purchase a 1930 Deluxe Roadster and we are having one heck of a time getting it to stay running. Symptoms: When cold engine runs and sounds great. Lots of power. The minute it gets up to temp.......backfires, jerks...

For those of you who have a trunk rack. I got a rusty rack that once cleaned up will be put in service. My question: Anyone have pictures and description of how the bolts, acorn nuts and washers attach? Are there spacers? What keeps the rack in the up position when the trunk is not on it? I...

Anyone have mounting measurements as to exactly where they mount? Prefer not to drill holes in the wrong location! :( Not sure what is going on but the rumble seat on this coupe may have one time been a trunk coupe?

Went to check my oil level after a run and just about burned my fingers.........:( Dipstick suppose to get that hot?

Just rebuilt my engine with insert bearings on mains and rods. Nothing else was done. Replaced everything back to where it came from. Engine runs quiet and smooth. Timing is fine. Drives well. Took an IR reading after a good run. Top front head reads 210F and bottom rear 157F, Rad top front...

Anyone using these? I'm thinking they have been replaced by a different setup.

30 over pistons. Pulled them for a small rebuild.....removed babbitt and now full insert motor. My question.....which way do these go back in? Forgot to take note when removing. :mad:

Anyone have a suggestion for a good wiper blade for the A? I know many of them flop and float in the wind and provide very poor wiping motion while in use. I have an elec 6v motor and I'm looking for a good clean sweeping blade. If I have to modify the arm, that's Ok. Getting caught in a...

I have a '48-50's pickup "78" case open drive trans I would like to convert to closed drive (torque tube). Issues?

Would this be a date of the block on my 59A?

Any idea what year this intake is? Thanks

So, a small mess on my hands here with the sheet metal and hinges on my rumble seat. I'll get the sheet metal fixed. My question.......are there bolts or screws holding the hinges to the rumble lid? If bolts how do you get the nut on the inside of the sheet metal? Thanks in advance.

Wanted: An original set of these, please!

Which is correct? Les Andrews book shows the right brake arm but supplier shows a different picture of the right arm? Does the arm where the rod attaches curve in towards the backing plate as per Les or away towards the center of the rear axle as Supplier lists? Thanks.

Well 2020 as we all know has not been the very best of years but........there is still nice in the world. Fall foliage is a favorite of mine. How about we share some of it.........:)

A short run with a few friends and wonderful scenery.

Oil going to blow out the dip stick hole?

Anyone have an idea as to year and made for vehicle?