Search results

All original with a few exceptions 817-648-4701

Looking for an original Door Striker for a Model A.

Did the 28-29 Roadsters have any sort of swing arm for the windshield? B.G.

Does anybody have the dimensions for mounting the tail light brakets on the rear fenders (obviously). Maybe a dimension from the quarterpanel surface to the center of the top of the bracket and a dimension from the lower edge of the fender to the approximate center of the 3 hole pattern...

I need some info about the alignment of the rear fenders for a 29 roadster. Should the top front corner of the curve that wraps around the splash shield be at the same height as the lower edge of the quarterpanel, or is there usually some misalignment? My fenders at those corners hang below the...

Can someone tell me what the center clamp should be for a JUNE 1929 Roadster. Is it round or oval, and does it have the blue painted shields? B.G.

Can someone tell me how far the fender welting is supposed to be installed? Does it run also between the running boards and fenders? B.G.

Does anyone have a jack, jack handle and crank handle for a June 29 Roadster? Doesn't have to look pretty, just needs to be restorable. B.G.

Can anyone tell me the requirements for registering a Model A? My frame number matches the registration but the engine block is not the original and is not stamped with a number. Should I stamp the same number on the block and if so, what size lettering should it be? Should the star be included...

Can anyone take a picture or tell me how the long curved brackets are used when adding cowl lights to a 29 Roadster that never had them? There doesn't seem to be any rhyme or reason to the way they are supposed to install. B.G.

Can one of you guru's out there tell me how much camber there should be on the front wheels? I have a 29 Roadster with an all new front end. The engine is installed so most all of its weight is there. I probably have an angle of 2 to 3 degrees from the vertical out at the top. B.G.

Does anyone know the purpose of the small (3/4") bend on the lower back edge of the rumble seat platform. I have a 29 Roadster. This small bend also has a couple of 3" notches on both right and left side. It almost looks as though a small rectangular panel could be installed between this...