Search results

See attached flyer

Model T Parts Sale. Save the date. See attached flyer.

While trying to work out my sagging frame issue. I have found that the drivers door hinges are bent. I have looked in a couple of supply catalogs and I am not locating any. Are these being reproduced?? Or will I have to locate a nice set of used ones. I can straighten these I believe, the...

I have run into another problems with my 29 Murray project. The doors and hood are not aligning correctly. I was not aware of the issues a sagging frame can cause with door/hood alignment. Until after I read Les Andrew's book Vol 2. He states that the frame can be straightened but you need to...

I have come up with an issue with replacement exterior door handles for 29 Murray. I purchased from Snyders product # A-702350-C and A-702351-C door handles that fit a 28-29 4 drs, Cabriolets and Victoria's. These look just like mine with scroll type handle. The replacements have two issues...

The body is all painted and just about ready to be put back on the frame. The chassis is a rolling chassis with the front fenders, splash aprons and running boards etc. installed. The webbing is under the splash aprons and front fenders. I have from Snyders part# A-5000-P (Body Block Pad Set)...

I base coated and clear coated my Murray body this week. I have an area above the rear window that I believe is clear that is now rough. I waited my times between coats and when I was doing the clear I noticed that sunlight was beating down in that area. I think it was too hot for the clear as...

I am trying to figure out the various shades of maroon. I don't want the real dark shades as it may show up blackish.... I have looked at images of cars on the web and it is very hard to go by them. Which is the lightest maroon?? Ford Maroon or Mulberry Maroon

I have had two A short blocks done by Antique Engine Rebuilders out of Skokie, IL in the past. I checked his web page and found that he is not taking any new work and a new owner will take over at some point. I would like to get this engine down ASAP. Is there anyone within a 3 hour drive of...

Coming up on June 19th in Richmond Indiana will be a swap meet for Ford vehicles 1945 and older. I was to this meet a couple of times prior to the Covid issues to look around. Several dealers were there two years ago. So, I signed up for a couple of spots and will be taking a load of Model A...

I am installing sealed one side main bearings in my transmission. Do the seals both face the outside? Do I need to install the old baffle plates since I am using a sealed bearing?

My Murray project will be needing a new front windshield frame. I see one listed from Snyders's A-45410-AR. It states that it won't work for the Briggs. Are all the fordors that year (1929) take the same windshield frame other than Briggs??? I have not tried to look for an original yet...

On the 1929 Murray Fordor that I am working on I will be needing a dome light that sits above the rear window. It is a oval type, I am not seeing it in catalogs that I have. Anyone make that replacement that is oval??

Does anyone make rear fender in "Steel" for a 1929 Murray?? The ones that I have will take lots....of work.

I have just started on replacing some floor pans on a 1929 Murray Fordor. The one that I am having problems locating from the catalogs that I have is the one that is under the seat. In the car when I purchased it was a new one that said it was for Fordors. Nothing was said about the "Murray"...