Search results

What is the correct position on the squirt holes on the left and right side rods? I have rods with the same numbers from prior rebuilt I guess. Looked thru my books and been unable to find it. Thanks in advance

Working on a 8BA found three of the four plugs you drive in the crankshaft was in the oil pan. I have threaded the holes with 3/8 NPT tap. My question is would you install aluminum or steel Allen headed plugs? The steel plugs weigh about 132 grains and the aluminum plugs weigh 64 grains. Thanks...

I am looking to buy a air fuel ratio meter to tune my 8BA. It runs good, checked plugs not burning very clean they are black. Looking for recommendations for a good one and ones to stay away from. Thanks in advance

I am needed a pair of rear fenders for a 1940 I/2 ton pick up. thanks in advance Mike mrc500@hotmail.com

Hello, I am looking for a 1940 pick up passenger door. PM me or by email mrc500@hotmail.com thanks for your help Mike

I am getting ready to replace the boards in a 40 pick up bed. I have some cypress boards that I was thinking about using. In the past I only have used oak. Has any one tried the cypress boards before or think they would work ok? Thanks for your sugestions and advice Mike

On making my 40 pickup a better driver it was suggested changing out the four speed for a three speed transmission and changing the rear end gear ratio. In looking the parts I was wondering if it would be better to look for the 42 and up open drive line rear end and a three speed trans that...

Hello Great site, been reading for years and been able to answer many questions about my 40 pick up. The past year I have re-built a 51 merc engine and is ready to install. The pick up has the original 4 speed with the lever to put it in reverse. I have been told it would make a better...