Search results

Hello I was hoping someone could let me know if this old coil has a good Reputation ,It is a old mallory 6 volt magspark also is there one for pos. grnd and one for neg. grnd.It is a box type coil plastic or bakelite it has two ballast resistors on it,was going to use it on my 35 dive bell dist...

Well here it is,I have a 21a it was rebuilt many years ago.I took it apart and checked it out,i did not pull any pistons because everything looked all right I did check a bearing. The Cam and valves looked good and the cylinders have a slight ridge,seemed alright to me.I put it back together a...

I have a 3 bolt dist. with a 3 bolt coil,earlier model I am guessing.I had the wires and terminal plates and caps off of a 38 3 bolt,went to install them and the alinement slots are in different locations would I be correct that they are different or do i just rotate the terminal plate until it...

does anybody have the ruler method measurements for timing the 3 bolt helmet type distributor, all i can find is info on two bolt crab style. thanx in advance. Pete.

Hello, I have taken my 59 a down to re-gasket and clean and inspect.I have the cam with the press on oil pump drive gear.There have been a few problems with the gears slipping. I have read about pinning the gear does anyone have a pic.of this. can you drill between the cam and gear put in an...

I have an old flathead that was rebuilt and 20,000 miles put on it back in 1960. Then it was pulled and set in a 32 pick up and has been sitting since. I have taken the motor apart everything looks good and not to dirty. My question is about the fiber timing gear it is a press on it looks...