Search results

Looking for a good useable draglink for a 41 ford car.This is a bar with no bends i believe 35-41 are the same thank you

Hello I have a 41 ford trying to get the horn to work.I converted to 12 volts a while back I had no luck with the trumpets so went with a modern horn.I tested the horn and works I have it wired through a horn relay.I am trying to figure out the wire to horn ring how does it break contact.How...

one set of interior door handles not perfect slight chrome pitting but still shine up complete set asking 25 dollars shipped.Center dash strip which I only have 1 sold the other could use a replate 10 dollars shipped.Exterior door handles both have some dings in them 15 dollars shipped

Offset gen bracket off 8ba nice shape the band seems a little distorted with a slight bend.And tough pivoting needs oil asking 35 dollars shipped.And a set of thermostat housing cast 15 dollars shipped gen bracket sold pending water housings sold

I need some help from someone who has gone from 6 to 12 volt and changed polarity to neg. I can get my horns to work but not off the three terminal relay.I have insulated the horns that may be a problem. s terminal to horn button h terminal horns b terminal to pos on battery this is a 41...

I have a 8ba block I hate to dispose of but need to get it out of my dads garage. I was going to rebuild it decided to repair my 59 block. I do not have any history on this block I can say it was stored under cover there is no heavy rust cylinders look good the cam and valves still in block...

Hello I am looking for a fuel and temp gauge and temp sending unit for a 56- 61 ford thank you paul pbc64@yahoo.com

Hello could someone please help me out i have a 41 ford i just rebuilt a 59ab it runs great i converted to 12 volts neg ground i am now running a gm altinator i have tried a coil with a internal resister and external resister coil with the ballast resister please excuse my spelling my wiring...

hello not sure if my oil gauge is working correctly when ignition swich is on motor not running it goes to the high side when the motor is running its allways pegged out on the high side it just not seem very accurate normally a oil gauge will fluxuate a little thanks paul

was installing my clock 41 super deluxe was extra carefull not to lose the screw that holds the knob on well I lost it I didn't even get mad would anyone have an extra or a junk clock that has one this knob is on the front of clock maybe a 41 merc clock would be the same thanks paul

Can anyone tell me how the gasket is installed on the v8 the gasket that goes on the intake fuel pump theres the fuel pump rod and the sleeve that keeps the pump rod in place i know this sounds confusing does the gasket go on the intake first and the sleeve sits on top of gasket thanks paul

nice esso road map from 1936 near mint condition 10.00 includes shipping paul

hello can anyone tell me how to take the shifter off the top ****** cover below the stick theres a ring is it screwed on or spring loaded thanks paul

would any one know the measurement of the bolts for the aluminum timing gear on the cam also are washers required on the 59a block thanks paul

deleted

what would be a safe solution i can use to take dried cosmoline off n.o.s bearings thanks paul

looking for a pair of front wing window gears for a 41 ford sedan thanks paul

need two valves for a model 59 block mushroom style thank you paul

looking for four valves for a 47 v8 block paul pbc64@yahoo.com

have a pair of 42-48 stainless steel gauge bezels right and left no ford script might be for merc 15 plus shipping paul