Search results

What modern Model A starter drive interchanges with stock A drive ford tractor "LOOKS" right Jerry in Shasta

I can't get to my car right now. What is the diameter of the steering tie rod? Thanks JB

We lost the copper tube, in shop fire, that goes from the engine to the side cover filter. Can any supply this, or tell me how to make one? Thanks Jerry

My roadster let out a very loud back fire and died and will not restart. I have spark, fuel, and compression. compression #1-75 the other three 65 The only thing found is the timing pointer is about 20 degrees from where should be. Is possible that the crankshaft key sheared?

Where can I get a gasket set for Marvel Schebller tsx carb? Thanks Jerry

I have done a lot of searching but I can't find the later model vehicle that uses the pressure plate we have used as a replacement for the original. Either lever or diaphragm type. ,,can anybody help? TIA Jerry

I need a usable Model A engine, short block OK,need something to run until can run until I can get mine rebuilt. Please no further than about a two hour drive from Redding CA. Thanks Jerry jebronson@shasta.com

some where I've seen the name of devise for setting toe-in. I'll be darned if I can find it now. A body got an idea what I'm looking for. Thanks JB

some where I've seen the name of devise for setting toe-in. I'll be darned if I can find it now. A body got an idea what I'm looking for. Thanks JB

Can the pressure plate be adjusted in the car? If so what are some of the tips? Thanks JB

Just started a new rebulit engine. Ptoblem is the front maing braring bolts are leaking a lot of oil from under the nuts.on top. I'm told that G.M. has a wsher that will stop the leak,. I also might try a very thin "O" ring under the bolt head. Any idea if there ia such a G.M. washer and...

We need a pair of serviceable 1935 Ford brake drums and hubs. We have the '35 spindles and other parts, only need the drums and hubs to complete the job. Thanks Jerry

Les Andrews, instructions says to have the slotted rivet at the bottom of the gear box pointed vertical. Is that vertical pointed at the sector shaft, or vertical as when it is mounted in the car? Thanks JB

Which of the Penrite steering gear lube is right for a Model A? Thanks JB

My questions are How many Ham/Model A operators are there. Is there any interest in try to get operators and repeater sites published the the member list? Thanks Jb kk6jeb

Just finished having cast iron brake drums swedged on the hubs. As part of the reinstall. I pumped grease thru the rear bearing zerk, the grease came out between end of the axle housing and the axle, this correct? I had to give it 6 pumps to get the grease to come out. I plan on packing the...

The site below has all kinds of info on the T5 Trans http://www.moderndriveline.com/Technical_Bits/article-index.htm?tag=trans

"if you can't fix it with a hammer, you've got an electrical problem"

I have a repo Thomas aluminum head. I want to mount a sacrificial anode in the head. Does any one know where I could drill and tap the side of the head and install a 5 inch long rod into the head with out interfering with coolant flow, or the anode touchng any of the interior of the cooling...

What spark plug is recommend for a repo Thomas head, 6.7 compression? Mostly local driving. Thanks JB