Search results

  1. A

    Need a new float

    I need a new float for my 47 ford model 59 # 94 carb any suggestions?
  2. A

    cooling and heating problem

    I have searched for this prob. Can't find the answer.This is a 47 tudor with 59ab. stock except headers and elec fuel pump.I have a very good and clear rad and heater cores.I have good wide opening stats I tested at 180 fully open.I also have dual temp ga. and Y'd in both heads to heater.Have...
  3. A

    Steeringbox rebuild?

    Have a late 47 tudor sedan that has about 5in. of play in steering and I want to rebuild the steering.The car has all new components(tie rods.panhard bushings,kingpins,draglink). My ?, macs shows lots of parts for this yr.what do I need?17to1 15to1, all shims, gaskets ,sector,worm? This is the...
  4. A

    outside trim time

    Anyone have a diagram showing clip placement on chrome trim?I have a 47 tudor sedan have been working on for 2 yrs.Will be buffing out new paint this weekend.Have all the trim polished up and ready, have the complete clip kit from Macs.Is there some kind of diagram showing where wire clips...
  5. A

    Need rear splash pan side pieces 1947

    need to finish up my project these two pieces bolt to splash pan an fender.
  6. A

    This puzzle has me beat.

    Finally putting my 47 tudor back together and can't figure out some shielding and brackets on frontend. Is there a better schematic than my green bible for breakdown or blowup of front clip? It was in boxes when I got it and most of it I figured out. Thanks for any help:confused: Marty
  7. A

    Check out my progress.on profile

    Coming along well for 4 months in. Have not figured out how to post to forum.New rebel wiring going in today. Watcha think?
  8. A

    making progress.

    Finished up chassis yesterday and pushed out of shop,and brought body in to start it.(Pictures on my profile)Frame down and blasted ,built air bag mnt. and put 3.5 drop speedway axle in front.I am trying air this time for the ride, am tired of old suspensions (getting old and soft Lol)Been...
  9. A

    painting ?s

    I'm redoing my 47 tudor.Am going with ppg omni.Have it down to metal.my ?s are can I use Glazing for small dings and bondo for big then etch primer?Do I sand etch primer before epoxy then sand epoxy(wet) then high build prime(wet?) then paint? So many conflicting threads on painting and brands...
  10. A

    need a few parts

    Hi all Just got frame blasted and por-15'd will start reassemble but need trans mt. pan-hard bushings frnt and back,sway bar bushings.This is for a 47 ford tudor. thanks marty
  11. A

    Pics test

    See if this works.47 ford 57 rambler
  12. A

    posting pic?

    New to site and don't know how to post pics.Tried to search for how to and no luck.Not real comp. savy. Thanks Marty
  13. A

    From Alaska.

    Just joined the barn and noticed Ak members.My 47 is my first flattie.I have it down to little pieces and starting rebuild.Frame blasted next wk and go from there.Was just wondering who is in Ak. would like to meet or talk with fellow members.swap parts and see whats up here. Thanks Marty
Back
Top