Search results

I have a new rear hub puller 25.00 brake centering tool 30.00 3 1/6 rivet tool 20.00 Clutch centering tool 3.00 Tie rod end socket 3.00 Brake adjusting wrench 3.00 Brand new not in wrap les Andrews red and green volume 1 @2 60 for both. All free shipping. Can't figure out how to upload...

Does the windshield hinge go in before the side garnish moldings? Or do the garnish moldings go in first then the hinge? It's. 29 ccpu.

Pair of what I think are original wood door posts. They are in very nice shape. 1-570-561-3569

Wood for the seat riser used on a 28-29ccpu. It is brand new from a wood kit purchased from snyders. It is a classic wood product. 1570-561-3569

Ccpu upper middle window panel. I bought the upper and lower as a set at Hershey. It is a repro and I don't need it. Will work with you on shipping.1-570-561-3569. Having trouble uploading pics. Will send them to you email.

In need of a 28-29 drivers side cab corner. Lower corner damage and rust is ok.

Does anyone know how tall each center rear panel is for a 28-29 ccpu I'm looking for a measurement of each panel not both panels assembled together.

What is the best way to peen the rivet without bending the rivet itself. I've bent 2 trying to flatten the end.

In need of a drivers side door or a 28-29 Ccpu. Any help is appreciated.

In need of a drivers side door o a 26-27 coupe or 2 dr sedan. Any help s appreciated.

I'm thinking of installing the battery disconnect that mounts on the starter. I use the fuse mounted on the starter switch. Is the disconnect necessary with the fuse?

I'm rebuilding my gauge. I'm using cork gaskets and the modern float. Someone before me had worked on the gauge because the float is to long. The bracket is ending inside the float. Can I slice the float to fit the float arm and if so will that harm the resistance to todays gases. Or is it...

Hey guys, yesterday I placed my rear drums on axle. Tightened down and pinned nut. Both washers are correctly in place? Brakes are centered and wedge is backed out all the way(after noticing drag I backed I out). I have a super heavy drag on both rear drums. I used shims on the axles. Greased...

Does anyone know how thick the wood in the bed is. The floor wood not the sills. Thanks a ton

Is the clutch fork for a model a the same as the 32 on v8 vehicles?

How much manifold sag is too much?

I am using a flat to crank guide in my 28 pickup. Are the lower plates universal for years 28-31 or is the lower plate also year specific. I'm asking because I have tightened the nuts equally as far as I can and I cannot place cotter pin in. Upper spring is beveled and pack is tight. Spring...

Doing the final torquing to 55 lbs on nut number 8 in sequence. That threads in block gave away. Won't hold torque. What are my options? Can I leave go( probably not). I really don't want to pull head AGAIN. Can I remove stud use head as a guide to drill for 1/2 13 tape . Then drill out...

I'm looking for a pair of running boards for a 28-29 ccpu.

Good morning, yesterday I pulled my head. No broken studs that was a relief. Head came off very easily. Took a really old look at head surface. Looks very nice no rust, burn out marks or gouges. Copper gasket looks very clean. No signs of leaks or lifting. Deck surface of block is really...