Search results

I want to replace the motor mounts for a 1929 Coupe. The car is clean and runs fine, but needs them replaced. What is the estimated time to do the job? How about the time to replace the clutch and resurface the flywheel? Any help is appreciated. Thanks.

1929 coupe. Car runs and shifts fine. Recently I’ve heard a slight rubbing noise when the car moves in reverse. Occurs on rotation of the gear at one spot. All the others gears are good. Has fresh gear oil. Thought about replacing gear oil with STP, increase viscosity may help; or do...

Are the door straps mounted outside or inside the lining of the door and interior? Inside doesn’t seem right to me. Thanks

The picture is of a 1929 Model A Special Coupe trunk area. I have circled the area that I cannot figure out what is mounted there. I do not believe the frame has been modified and I think it is an original part of the car. Any help to explain what is mounted here would be a big help. Thanks

I’m installing repro gas gauge. I can’t get the outer ring to seat with the gauge assembly in place. I remove the gauge assembly and I can easily screw the outer ring in place, nice and tight. I have followed the schematic for the gaskets and I’m confident this is done correctly. I have...

Anyone have a problem getting a new Carb, Tillotson, Air Balanced to run? I had to make a lot of adjustments to the float level to get to run when I first got it. I bent the float and used shims. After a few days of running well it stop and I have had problems since. My fuel is clean. Ive...

I’d need help in installing the cowell lacing using wire. I have all the parts but I have not been able to locate the way to install. Any help is much appreciated.

This is a new carb and can’t start. Good fuel getting to the inlet of carb, and the gas flows thru valve great but wont start unless I use starter fluid, then runs and stops. New carb, wouldn’t think I’d have to set the float, but out of ideas. Timing is good and fuel is good. Help. Thanks