Search results

here is a new form of sustainability. One of the previous owners ruined the thread of the axle shaft on one side by improperly removing the hub. The lathe operator did a good job. The connector is a 5 mm precision cylinder tube 30cm long, shrunk onto the stub shafts. Drilled 8x diameter 12mm x...

A torque wrench only for the rear axle was too expensive for me. I have already set. Can someone please recalculate. It seems so tough to me.20 inch pounds is the Task. Same procedure as with my Land Rover,only tighter. Thanks

I tried to align the flywheel housing with the crank. Without papergasket it`s easy to proceed the job, set from BILL BARLOW. Shimming here, shimming there, after 30 min. the job is done. Instead of using now the thick paper gasket I apply a string of silicone sealant the whole length of the...

greetings from lake constance Rebuilt my engine with modern main shells, new rods, pistons, oil pump, B-cam, pump drivegear. Filled the 5 liter engine oil and pressed the starter button. When the oil reached the chamber to the right I stopped and mounted the valve cover. For pumping the oil to...

I decided to buy a weber dgv for my baquets standard engine. Someone very satisfied with this carburetor, possible tell me the jet setting? Thanks in advance. Rik

Hello, I restore a ford a baquet from uruguay. I suspect engine block and cylinder head was skimmed much to increase the compression. The engine builder now skimmed only the necessary minimal thickness and warned me to pay attention when assemble the engine. Now after crank, connecting rod and...