Search results

shoe box parts for sale 8ba engine parts drivers side head gasket oil pan gasket partial piston ring set piston (knurled ) 1 rod bearings 1951 complete instrument cluster ( all gauges) work

1951 ford 4:11 rear-- excellent condition--best offer

This is an old question I posted a while back but it's come back to haunt me so I"ll try it again. The shop manual for my stock 1951 8ba calls for an ignition coil with a primary resistance reading of 1.05 to 1.15 and a secondary reading of 4,100. The Echlin coil listed for this car is a Ech...

Complete 1951 ford differential, minus brake hardware and shoes, excellent condition. This complete rear is ready to install and run, stock with a 3:90 or 4:11 ratio.

looking for a way to lower the RPM at cruising speed by changing the stock differential gear ratio on my friends 1951 ford convertible. It's powered by a 302 with C4 auto trans with no overdrive. With the stock rear at 3.9 gear ratio it runs 3,000 RPM's at 50 miles an hour. He's not interested...

Whats your opinion on this PCV valve kit for my 51 8ba. Instructions say to remove crankcase breather pipe and plug in pcv and adapter plug. Tee hose into hose on bottom of carburetor that is used for wiper motor. I assume incoming air will be supplied by the vented cap on the oil fill pipe.

two sets of ford hubcaps- all in excellent condition- One set with red center. 2nd set all chrome color

49-50-51-ford parts-wiper blades-hub caps -chrome thermostat housings-voltage regulator-drivers side ex manifold

1951 ford drivers side tie rod -new

complete 1951 ford instrument cluster- all gauges and speedometer working when taken out of car

1951 ford dash mount heater control-excellent condition

left and right water pumps--working when taken out of car

1951 ford radiator-- original -worked when taken out of car-probably needs rebuild

I have a stock 1951 8BA I would like to install a power (valve block off plug) in my 94 holly carburetor to determine once and for all if this is the source of my leak down problem. What can I expect as far as performance with no power valve? Attached is a picture of the plug I will be...

I have an oil pan gasket set from Felpro #os 2996 c-1 for my 51 ford 8ba. It came with 3 rope seals - 1 thick straight black - 1 thick curved white and 1 thinner straight white. No instructions - I assume the thick black goes in the pan for rear seal, thick curved white is for pan front seal -...

has anyone replaced the O ring in this 1951 heater control valve?

I have a completely stock 1951 ford victoria with stock v8 with stick shift. I've had a slight noise and vibration from the drive train, so I jacked up both rear wheels to spin them and see if i could hear anything. Here's where it gets crazy, both wheels spin freely with no drag or noise but...

this taillight spear on my 51 is in good shape but it has what i'll call scuff marks on it and i'd like to clean it up. I'm not sure if it is chrome or stainless, I'm guessing it's chrome and I've tried several types of cleaner and polish with no success-- any ideas? You can only buy them new in...

is there a way to adjust the side to side gap on my 1951 ford hood. Hood needs to move to the right so the gap on both sides will be the same. pictured attached.

gradually over the past 6 months my 51 8ba with dual exhaust has been rapping and popping from the exhaust. This only happens when backing down in second or third gear and can get pretty loud. The car has Cherry Bomb glasspacks but did not make this noise for the first three years. Could they...