Search results

Trying to remove steering drag link on 38 sedan. I removed cotter pin and nut but do not want to tap to hard to drive out-what is the best way to drive link out with out damage-Thx

Guys-Where is the vent hole for the standard 38 trans on my 85 hp Ford Standard? Could not find it on the shift tower if that's where it is supposed to be-Thanks

Need new repop or excellent bumper guards for 1937 for standard front bumper-Thanks Dan

Guys-Needing to replace my old striker plates on my 38 Sedan. Question -when I remove the screws are there nuts on the back that will fall into the door or are they on a plate-Thanks

Guys-I removed the lock cylinder out of the Trunk Handle on my 1938 Ford Standard Sedan to take to a locksmith to get re keyed. He says the cylinder is shot and I need to find a new one. Does anyone no of a source for this lock cylinder? It is the one that has the little locking pin that sticks...

I'm in the process of getting all my locks working-My passenger door now works fine but need to replace lock on truck lever-any tips?

Just replaced my Door lock with a new repop-my old one did not have a key-the internals in the door only turn a half turn and do not lock or unlock with new Door Lock-any ideas -Thanks

Guys-Need to replace the rear window channels in my 38 Ford Standard Sedan-Can this be done with the windows in and are any special tools needed-Thx All

Guys - Just wanting some input from the pros- My 1938 Ford Standard has the following casting stamps on the heads- Right Head-81A-050 and a 47 plus the ford logo-Left-81A-050 and a 44 plus ford logo and the intake has a number 3 in a circle followed by a -2--are the numbers correct for the year...

Quick question-proper spark plug gap for 38 Ford numbers matching engine-Thanks Dan

Guys-Going to remove my front shocks from my 1938 Ford Standard for rebuild. Question-do I put jacks under frame or axle to remove shocks-Also have never been off car so how hard are they to remove-Thanks for your help

Guys- Putting in new Color Coded spark plug wires-How is the best way to feed them in to the wire looms -all together or one at a time? Also on the left side where the Gen cut out and coil wire go through how is the best way to feed that bundle? Also the brass clips that go on the end of each...

Guys- I'm cleaning up my engine compartment on my 38 Ford Standard-Engine Block and heads are painted correct Green -What color are the Spark Plug Wire Metal Tubes? Green or Black or?-Thx

Hey Guys- I have to hold up the hood on my 1938 Ford Standard Sedan with a stick- Is this the way they were or am I missing something in my Hood Hinges-Thx

Hello Guys- New to the Ford Barn and these Flatheads. I have a 1938 Ford Standard Sedan with the 85 Flathead all stock. I ordered a gasket set from MAC's for my Carb because it was a little wet after my drives. Since I have installed all the gaskets the Engine is running VERY rich and I can not...

Need complete Front Grille center strip with crank hole for 1938 Ford Standard-THX