Search results

I need 10 posts before I can PM.

I can not PM until I have 10 posts. Hope this test post counts.

The pilot bearing does not fit snugly on the trans input shaft. Measuring shows that the shaft is .002 smaller than the pilot bearing. Is this a problem? If so, could a brass shim ring be used?

One .010 ford script piston in good condition and one .010 ford script piston in marginal condition. Also have two after market .040 pistons which have non standard ring thickness. The rings grooves are 1/8 5/32 & 5/32.

The May 1929 Ford Service Bulletin has a procedure to drill a hole to oil the rear camshaft bearing. I have a Dec 28 motor and there is no issue with rear bearing wear. Is the oil hole .... not needed ..... recommended ..... or critical? If the oil hole is added, will it create more problems...

I am doing a valve job and have an issue with the valve springs. Les Andrews’ book has the specifications of 2-15/16” free length with 57-64 lbs of compression at 2-1/4”. The valve seats are original (ie not hardened inserts). Which of the three options below would you choose: (1) The...