Search results

Hello had to clean up the rear tight light for better light output. found the backup lights working only in park shift position and the light switch is set to an on position.Is this correct setting for the lights to go out when backing up.

Happy Holidays At this time working on replacing original body mounts . According to the ford manual the rubber style bushings must be tighten every 9000 miles. So are there urethane bushings available in the market place. Next The air intake-panels behind the grill on my galaxie were cobbled...

Anybody have any trick or treats for replacement of body mounts when the body is attached to the frame. heard lifting the body requires braces required to prevent twisting the body at the doors B post.

Good Day, have a question regarding using a 32 front axles assembly on a model a. Would I need to replace the 32 King pins with model A king pins in order to stay with the model A brake actuator rods setup.The 32 actuators angle in towards the center of the car.

Need a little refresher, what is the correct the standard 1929 roadster front wind frame color? Black, nickel or body color. Appreciate a one liner

Had to patch both wheel wells along with lower quarter panels. The panels are clamped in place oon the new sub frame, looks good to go but... Does anyone have pictures showing the quarter panel flange area attaching onto the sub frame. Know the original metal flange was notched about an inch in...

The rumble seat pan rear flange is notched on either end. The inside rumble pan does not seal to the sub frame to keep weather out what is missing. Also the front pan flange overlaps the mounting bolt holes and there is a gap on either side of the pan and sub frame same question weather...

Good day gentlemen, started process of dry assembly the rear quarter panels to a new sub frame using the original panels, upper deck lid panel & seat pan. Question what is the correct width across the quarter panels at the door posts top. By taking multiple measurements the passenger side...

When sand blasting the panel there were three holes grouped very close together for the little rubber bumpers used to support the glass when top is down. Can someone provide the distance between these bumpers from front to back of car. The two nearest the deck lid are original so width is set...