Search results

Here is one I have never heard of from a Fahnestock v8 service handbook, 1937. "In cases of severe trouble with overheating, Ford dealers can make a hacksaw cut in the bottom tank of the radiator, and then solder in a piece of sheet copper which will divide the bottom tank into two...

HODA236132 Can someone please break this down: MFG plant Color Engine and anything else, like rear end ratio Thanks

what year did Ford go to thin fan belts, high oil filter and dual fuel/vac pump

My 34 sets to low on the aftermarket spring that came with it and I am rehabbing a original 33/4 front spring. Car is a sedan and book calls for 12 leaves and I only have ten. So far I have wire brushed with a grinder and next will go thru with a grinder to smooth the indentions at the end of...

What is the latest news about the MtFCA forum? Its slow as can be again after all the bells and whistles put in to stop the snotty nose hackers.

Anyone had experience rebuilding/fixing one of these and stopping the horn rod from slipping on the switch. This is a total different animal than the later switches.

Could someone please send me some contact information for who ever has used parts for the Heyer Distributor machine.

How do you tell the difference between a 35 and 36 rh taillight stand?

Were the early 32 driveshaft bearings more prone to fail than later?

Anyone notice the abundance of GM junk listed under flathead ford and 32 ford on ebay. Guess they cannot get rid of their junk on proper descriptions so they bog down Ford listings.

Looking for repair information and wiring diagram for the late Heyer machine. That's the one with the vertical manometer mounted on it, I think these machines were brought out around 1948.

Did Ford offer power steering as a option on 53 cars?

What length push rod works with the 48 and under and what push rod works with the 49 to 53. I have several of these pumps and would like to try running one.

I am converting a straight shift 53 to a overdrive. So far we have all the correct parts, transmission with sol., gov. relay, kickdown switch and wire harness. It appears that reversing the plate that the trans mt is clampted to will make up for the different length. Could someone that has...

Could someone please post a source and contact info for the GM dist setup for the late flatheads.

Anyone that has done this and is willing to share experience, please reply with private msg.

Whats with the MTFCA forum, down an awful long time............

Is there a recommended method to remove a worn out bushing in the top of a 34 steering column without removing the column? Need a source for a non vented gas cap so I can stop my car from sloshing gas when full. 32 to 35s with the hydrostatic gauge should have a non vented cap.

Broke an axle in my 34 yesterday, no pop just all of a sudden the engine speeded up. It's on the drivers side of the Columbia so I hope to pull the right housing, Columbia side instead of pulling the rear end. Anybody got a extra 18 tooth 33/4 axle, I amd in the market for one. Please PM me.

one of my toys, if the pics come thru