Search results

https://www.jalopyjournal.com/forum/threads/1939-1940-ford-parts-worth-selling-or-send-to-the-crusher.1238274/

Has anyone seen Jovial Jeff lurking around the barn again? Jack E/NJ

Don't recall if this was posted before. Near the ***bottom*** part of this link, ~$40 kits are available for converting any common 12V negative ground 10SI/12SI alternator to 6, 8 or 12V positive-ground for either 1- or standard 3-wire operation. Jack E/NJ...

Hi y'all Long ago I acquired an old farm tractor rigged with a '48 motor. It currently has two 3/8" headstuds as quick 'drill&tap' replacements for broken-off originals. These two small-diameter studs are separated by one normal 7/16" stud located near the top of #1 cylinder. It's been running...

Send me a PM if you want them. They must be picked up near Phillipsburg NJ. Heads need a shave to remove some shallow potholes or JB Weld to fill them. Thanks. Jack E/NJ

Thought y'all might be interested in this piece from http://www.rockauto.com/Newsletter/index.html Jack E/NJ My Garage Experiment by Tom Taylor, RockAuto.com I tend to put anti-seize compound on most bolts. After struggling to remove a frozen fastener, I want to make sure that it is easier...

A local shop just re-surfaced my flywheel. They claim its engine-side also had to be re-surfaced for best clutch operation --- an extra charge of course. Does this engine-side shave make any sense? Thanks Jack E/NJ

How are the impeller & pulley affixed to the water pump shaft? Are they pressed on? How best to separate them from the shaft? Thanks! Jack E/NJ

Found this on the aaca buick site for anyone that might be interested. photos http://www.pagesgarage.com/Mod%20A%20Ford.htm description scroll down http://www.pagesgarage.com Jack E/NJ

Any thoughts on using a filtered breather cap with an integrated PCV valve vs. one with a simple PCV tube to the air cleaner? Thanks. Jack E/NJ

I want to remove the mechanical fuel pump stand & pushrod assembly altogether. Any suggestions for easily plugging the pushrod sleeve bearing in the block without damaging it? Thanks Jack E/NJ