Search results

  1. C

    Canadian or Cheater 59a Alu heads

    I have these two heads that came of the same engine. I am a about to do final assembly of my 59a engine and suddenly discover that there is a difference in the combustion chamber design and thereby Volumen - can any confirm or disconfirm if this is right thank you
  2. C

    Where to buy 21 stud repro alu heads

    I am rebuilding a 1036 LB engine and are looking for aluminum heads, any good souces to reach out to thanks
  3. C

    0.060 dome pistons for a LB motor

    I am looking for 0.060 dome pistons for my 1936 LB motor - any recommendations? NOS is of course preferred thanks
  4. C

    1932 Ford V8 vs 4 cyl horsepower

    Hello, I am looking for documentation that specifies the horsepower for a 1932 V8 and 4 banger. It is for the authorities so Wikipedia is not good enough. It could be a manual, handbook, sales brochure or similar Thansk
  5. C

    1932 ford light switch

    Any good advise on where to find an original or high quality light switch ? thank you
  6. C

    1932 Ford Roadster wiper motor

    looking for an original wiper motor for my Henry Roadster thx
  7. C

    1400 Harmon Collins points

    I am looking for a set of bendix points for my 1400 HC dual coil - anyone know where to get these Thx Carsten
  8. C

    1932 Roadster door handles

    I am looking for cabin door handles to my 32 henry roadster thank you Carsten
  9. C

    32 Roadster windsheild repro vs original

    Hello, I found and original windsheild - I think - is there a way to see the difference between an original and a reproduction ?
  10. C

    How to remove head studs

    I am looking for good advise on how to loosen the hread studs without breaking them off.
  11. C

    32 Ford Roadster windsheild

    After collecting parts for my orignal 32 Roadster for years, I am now very close to the finish line. The last part I need is an orignal windsheild frame and upper stanchoins - I know it is a hard one and they are rare but fingers crossed that someone in here can help thank you
  12. C

    What Cam to choose

    I am going to rebuild a 21 stud engine from 1938. It is going to be used in a 32 Roadster. I would like to build a sharp/fast and reliable engine and have already a few performance parts. I have an original PM7 with original paint and everything, a pair of aluminum head from Canada and a harmon...
  13. C

    1932 Ford Roadster wiring

    Hello, I am going to install a new wiring harness and are looking for blue prints that shows how the "path" is on the chassie and what clips to use. The same for the engine compartment. Thank you
Back
Top