Search results

After 90 years of service, the transmission gave up today and will need to be removed for repair. Is it possible, or practical, to remove it to the rear leaving the engine in place, or should I just pull the engine and go out the front? I've never worked with a closed driveshaft before...

Used engine parts. I hate to scrap them if someone wants original parts. Any or all, $20 plus shipping.

Used OEM oil pump and pick up. ‘38- $75.00 plus shipping.

9” Clutch and pressure plate Used 9” clutch and pressure plate. $75.00 plus shipping

For the first time today, I had the starter lock up on the flywheel. Once I got the starter removed everything was free and looked fine. Should I just reinstall the starter and hope for many more problem free starts or are there other repairs I should be considering? Motor is an early 24...

Most of our Fords are hibernating for the winter but if you have a winter picture you like, share it here. Thinking of warmer weather.......

This is for the truck in the avatar, 1936, motor is a 1940, fresh rebuild, helmet distributor rebuilt by Bubba, 6V positive ground. I ended up going back to a remote coil, Echlin IC7 with a FA54 condenser, no resistor in the circuit. I currently have the -6V from the ignition switch going...

Engine back from a fresh rebuild. I plan on using the helmet head distributor that came off. Looking at it last night I noticed the cam seemed to be set back too far for the distributor to reach. Sure enough it is. The cam that came out has the pressed on fiber gear. The new cam is an Isky...

Scratch post. I found the info I was looking for. Thanks.

Looking for engine stand adapter for 85 HP flathead.

Anyone know where I can find, or care to guess the curb weight of the truck in my avatar? 1936 BB 1 1/2 ton with a Woods dump body. I know a truck scale would be best but that's not an option right now. Any help very much appreciated. Thanks!

Looking for 20" wheel for my '35 1 1/2 ton truck. Must be in good usable condition. PM me if you have anything or know of someone that does. Thanks

Looking for top carburetor air horn for Ford / Holley 94. Prefer newer version with internal bowl vent. Thanks

NOS 1935 1936 Ford passenger car and truck headlight wiring harness. $75.00. Free shipping.

This should be as easy one for everyone but me. I'm trying to ID the carburetor in my '35 so I can order a rebuild kit. The motor is not original to the truck. My best guess is it's around a 1940. Carb has Ford and "59" on the side and "94" on the back. So what do I have? What kit should I be...

Hi Everyone. I'm new here and new to early Ford trucks and The Ford Barn. Recently picked up a '35 truck and I'm in the process for getting it road worthy. It runs drives and dumps. I just need to get a few safety items taken care of. Nothing major, lights, wiper, mud flaps, stuff like that...