Search results

I have a 31 roadster with a B block and transmission. I have had it for about five years and driven the car during the restoration. Since finishing the restoration I drive it frequently with no problems. Today My brother and I took it out and after five miles of driving we thought we had blown a...

A while back I converted my 34 coupe to 12 volt negative ground. Had generator rebuilt with 12 volt field coils and had to buy a new 12 v voltage regulator. It would not keep the battery charged and the amp gauge always showed a discharge. I checked the generator by connecting the field and...

I'm trying to remove an engine out of a 24 T chassis. I have it free everywhere except the u joint is stuck in the back of the transmission. There doesn't seem to be any place to apply heat and soaking in penetrant hasn't helped. Motor is stuck so I can't rotate. Any advice appreciated. Steve

Hope someone can ID this T head, Rayfield carb, no other ID. Thanks, steve

I'm putting a Mitchell overdrive in my 34 coupe. It has a 4.11 rear end. When the overdrive arrived it came with a 6-10 spline coupler. My pinion is a six spline so I needed the 6-6 spline coupler. Is six spline correct for a 34\v-8? Or has someone changed it? Don't know what years used six...

Here's the scoop: 8BA in a 34 coupe. Decided to change over to 12 volt neg grnd, Swapped out the bulbs and such. Sent the gen to the shop for 12 v field coils, brushes etc. New optima 12 v battery. New 12 v regulator, New volt meter instead of amp guage. Put on the new generator, polarized it...

I just rebuilt the steering box on my 34 coupe and noticed that the three holes in the frame that it bolts to were elongated. Is this factory or has someone done it to lower the steering column? I was going to weld them up but thought I should ask first after reading that some 32's came with...

I wondered if anyone else has done this and can share some info. I have a 31 roadster with a "B" four cyl engine and transmission and a Mitchell OD installed. I would like to use the stick shifter and not the cable but the B transmission is one inch wider than the A at the top bolt pattern...

I'm rebuilding a couple of 31 roadsters and while putting on a new door skin I noticed a punched hole on the inner door next to the latch. Looked like a 357 shot through the door with jagged edges but not exiting the outer skin. At a Model A event with my club recently I had the opportunity to...

Does the 28 roadster top and irons fit the 28 RPU? Or can it be made to fit? Not looking for perfection here but a top that will work on a RPU. Thanks, Steve

I'm new here and starting work on a 31 roadster. The back half of my subrails and all 3 cross channels are junk and need to be replaced before I can start putting the body together. In looking at the ads for these from most of the suppliers, I notice that some are trim to fit, and some seem to...