Search results

I have a couple of steel (original 15" were optional) on my 50 Meteor. I have too much runout on two of the rims which I believe is causing a vibration problem. I have checked into straightening them and appears my best option is to find replacement wheels. Does anyone know where I could find a...

I have a trans and OD from (I believe) 50 Meteor/Ford. It could be restored or used for parts. I have disassembled it and believe it needs gaskets, seals, new retainer clips, 8a-7652 OD output shaft, cluster gear washers, tail shaft bushing and seal, front bearing retainer, solenoid and...

First the question; the car handles the trailer fine but overheating is the problem, so is this doable or is it just too much to expect out of this car? Background is; 8ba with OD, 3.88 rear end. The bore was within tolerances when I got the car so I did rings, bearings, valves, crank water...

This car did not come with a driveshaft, I "found" one and installed it and now am wondering if it is too short. The pic shows I have about 1-3/4" of the yoke barrel out of the transmission tailpiece, should the yoke be deeper into the tailpiece? This pic was taken with the car weight on the...

parts not needed

Can someone confirm that the pinion setting is set by crush washer or is it set by shims in this diff. Thanks for the help.

I attempted to install the bushing kit, the bushing and bolt match the originals but the supplied seals are one diameter only. I think if they had one larger end I could squeeze them in place? I do not have a old seal to compare. I really need someone who has installed these parts to chime in; I...