Search results

found a 1929 model a two door sedan in a barn need a pair of used running boards for it to make it complete my cell phone number is 9374596491 if you wish to call

my wiring diagram shows the dash light and the yellow wire with black tracer going to the + side of the amp gauge. which side is the + side. is it the side that is positive charge on the gauge? thanks bill

has anybody every tried to put a flathead v8 in a 1929 model a sedan

I have a 1935 ford coupe 5 window car. I am looking for a set of scuff plates for it. does any body know where I can pick up a set . thanks, bill

I have a 1935 ford coupe. I need to replace side glass in the door. what is the best way to get that window out of the door. thanks bill

I got my halfs of the hood set on the car and got my chrome piece that holds both sides together at top. is there anything that goes up under neath where the hood come together at. there is a one half inch gap in between the hood halfs and there is a lot of holes drilled on both pieces up under...

does anybody know where you can get the bulb holders that holds the bulbs that lights up the speedometer when it gets dark out. they snap in the holders on the back side of the speedometer housing

in my 1935 ford coupe how many different positons where on the head light switch? was there a park light and a high and low beam and also did the bulb ground through the head light assembly there is also a small bulb at the top of the reflector on the inside.also does anybody know where a...

I have a three quarter inch hole in my dash that I want to put a on off warning light. I have a 1935 ford coupe the light will be on when igniton swich is on but when the alternator starts charging the light will go off.all I need is a 12 volt push in light assembly. any ideas or part number...

I have a 1935 ford coupe that I am restoring. everything has bin going pretty good with the help of you guys on the ford barn. should had taken more pictures or wrote more things down. my queston is I got the front part of the headlines in and it looks good, no wrinkles, when you pull the back...

to the Greenmonster 48 can you give me the number of bernies so I can call him and send me generator to him thanks, bill

I switched my 35 ford coupe to 12 volts. by just using the same generator with the cut out relay on top, will it keep the battery charged up. also is the key switch on the side of the steering heavy enough to run a fuse panel off of it. the fuse panel will only have a couple of circuts on it...

I have a 1935 ford coupe with a vinyl top. when you put the vinyl over the opening on top do you cut the vinyl at the edge of the trough or do you tuck it under the lip and then put the rubber seal down in the channel

so far the ford barn has been good to me on info and finding parts. I am going to make this time a little tougher, I need a ornament for the top of the radiator on my 1935 ford coupe it is a delux model if that make a difference and a 5 window coupe thanks bill

my 1935 5 window coupe has a roll down back window. does anybody know of a place that sells the u channel seal that the window rolls up in when the window is up. everybody keeps sending me the seal for the stationary window. the rear seal looks like the seal that are on the door glass.

need information on where I can get door scuff plates for my 1935 coupe

I am looking for a transmission cover for my 1935 coupe it bolts on the floor to cover up trans

I am looking for a 1935 ford coupe grill that has already been chromed or that I can repaint. hope to get one that is in good shape. restoring a 35 and want something that will go good with it. you can e mail me at bluegrass@bright.net or call my cell at 1 937 459 6491

1935 ford coupe. changed over to 12 volt system. I got new wiring harness for the car. it is 6 volt. will running 12 volts through that wire hurt anything. like running the head lights and tail lights

I am looking for a front grill for a 1935 ford coupe.