Search results

This Auto Spec SJ 1839 jack made in Windsor Canada is seized by corrosion and hasn’t responded to penetrating oil. Do any members have any experience on how to take this jack apart or get it moving without damaging it?

Can oil pressure above 50 psi (actual) damage a 1937 original 50 psi oil pressure gauge and sender system? Or does the sender contact points cycle open and close on reaching 50 psi? I have been running on a direct reading pressure oil gauge since fitting the reconditioned engine. Yesterday I...

I am fitting new knobs to old throttle and choke rods in a 37 coupe. How do you accomodate the changing angle of the rods at the coupling when moving the rods forward and back? I presume the knob and small part of the shaft should be at right angles to the dash through the complete range.

Is the Detent in the outer edge of this 11-A cam plate there for a reason or is it it a blend out of damage?

I have a stripped thread on a distributor I am overhauling. What is the thread size of the vacuum connection?

I require a set of Door Dove Tail Springs for my 1937 Ford Coup’e with lighter springs than are available from our usual reproduction parts suppliers. I have read on the Barn that A&L in Connecticut has a supply of these lighter springs. Does any Barn member have a reference part number or a...

I am trying to install a set of Bob Drake bumper irons to the front of my 1937 coup’e. Do both legs of the irons bolt to the outside of the C section chassis vertical web or do they sandwich the vertical web?

I would like to purchase a U.S. made flasher can. The can is marketed under the Novita name and the part number is LL535. This can I am told will suit my 6 volt positive earth electrical system. There was a post on the Ford Barn by Graeme NZ who said he had purchased these from Rock Auto but I...

I am looking for a RHD wiring loom, dash and lights, for my 37 coup’e. Will a LHD loom connect up Ok?

37 5W Coup’e trunk boot woodwork. Does anyone have a photograph or drawing of the wooden frame which forms the bulkhead between the boot and the rear of the seat in a 1937 Standard Ford V8 Coup’e? I have most of the wooden parts but after taking this frame apart 40 years ago, I am now unsure...

Does any member have a drawing or a photo of the tail light loom run on a 1937 RHD 5window coup'e, especially in the area of the central chassis cross member box. Ramjet47

Can anyone advise me what my cars VIN A 40904 F indicates? The car is a 1937 5 window Std Coup'e, right hand drive. The VIN is marked on the right hand chasis member top channel above the steering box mount and on the top rear face of the gearbox bell housing. I purchased the car in New...

My 1937 5 widow Coup'e has door striker plate attachment captive nuts with .850" between centres. The only replacement door striker plates available from Dennis Carpenter have attachment holes with .750" between centres. Does any one know where I can purchase 2 off striker plates with .850"...