Search results

Looking for a source for a new or good used trunk lock cylinder for my 37 Coupe. Bob

I am looking for a new or good used cylinder and key for my 37 Coupe trunk handle. Thanks Bob

Does anyone have any experience, good or bad, with the Mallory Unilite Distributor (3772101) for use on a stock '37 85hp flathead (21 bolt). Or other thoughts... Thanks

Does anyone have any experience with the Eaton Company in Detroit for springs? Or any other company? I am looking to replace the front spring on my '37 coupe. Thanks

Does anyone have a good picture of how the hood rod (the flat rod that holds the hood open when extended in the latched position) attaches to the hood on an early '37 Coupe? Post or e-mail if you have something. BNewman13@earthlink.net. THANKS. Bob Tallahassee, FL

In looking for a way to wire up an electric wiper motor (Mighty Mite) in my '37 Coupe I realized that the cigar lighter was unused and unlikely to be ever used. I removed the lighter assembly and removed the element. Next I drilled a hole through the back of the housing small enough to just...

Does the heavy duty radiator Snyder sells have the correct tank baffle?

I have a head on my '31 I am told is a Brumfield. It has a small B just forward of the distributor and viewed correctly from the manifold side of the engine. Does anyone know what compression ratio it might be? Thanks

If I install an electric fuel pump near the tank on my 37 Coupe can I still leave the mechanical pump in place or do I have to remove it and install a block off plate? Any other thoughts on an electric fuel pump installation? Thanks. Bob

Is there a way to install an oil filter from a later year flathead on a '37 Ford engine? Bob

Advice Needed !! I have both the engine and transmission out of my '31 Victoria. My question is what is the better way for installation: 1. Engine and transmission as a unit? 2. Transmission & bell housing first, then engine with clutch and clutch housing attached. Thanks, Bob