Search results

I have a NOS voltage regulator made in Canada Part numberLV/FD/CAN C11A 10505-C is it for a passanger car or heavy duty truck generator?

I have I think an original ignition switch body, the three contacts on the back are two sizes. The battery and the gauge terminals are small and the coil terminal is much larger. I have a repro that is the same and a repro from Vintique that has the large terminal on the battery connection? I...

i have a very early 40 coupe and a mid year coupe and the key for the steering lock turns counter clockwise to unlock on one and cliockwise on the other car? does anyone know if there was a change or is one of my NOS cylinders wrong? Thanks in advance for the answer. I know there are a lot of...

I have a business coupe with jump seats and with my LeBaron Bonney interior kit I have covers for two foot rests that go behind the front seat. I have seen pictures on line and I know I can make them but I would like to be correct, I know the size and I assume they are made out of plywood and...

Need a ON-OFF switch or complete control for a Zenith radio also need the speaker boot.

I just bought a dry air cleaner for my 40 ford 85 hp. Stamped on the bottom is 78 9600 I can't find this number as is in the parts book and between the two ribs it measures 3 inches. The judging book says it should measure 3 5/8 inches. The question is what is it for? Thanks in advance for your...

Wanted complete short cigar lighter for a 40 ford, I have a radio.

Looking for someone who has a 40 Ford radio speaker boot. They were made by Drake but have been out of stock for sometime.

Looking for 40 Ford pass car bumpers must be straight and just in need of plating.

40 Ford pass. car bumpers must be straight and in need of plating only and have the two ribs on the back side.

WANTED: Original 40 ford pass. car bumpers, Must be straight and only in need of plating and have the two ribs on the rear side.

Wanted: Original 40 ford pass car bumpers in good condition just in need of plating.

WANTED: 40 ford coupe original bumper, must be straight with very little rust just in need of plating.

WANTED: 40 ford coupe original bumper, straight with very little rust just needing plating.

Looking for both RH and LH engine splash pans for a 40 ford.

I'm installing Bob Drakes trunk floor in a business coupe (fold down rear seats). I have enough of the original floor to know where to cut and install the new panel but i have nothing from the end of this panel foward to the top of the step, thats about 14 inches of unknown. would anyone who has...