Search results

My 40 Deluxe Coupe has only two bolts per side fixing running board to front fender. The fender has 4 bolt holes in it but the running board only has two. Original fenders and running boards. Is this correct? A picher would be good. Also I managed to break one of the small spring clips that...

Hello Guys, I have not posted here in a while, but still fiddling with pre war Fords. Our Australian Government has gone madder these days and are paranoid about asbestos entering the country in imported cars. My question is:- Does anyone know if these cars (34 Ford) have asbestos in them, and...

I have a problem with the front fenders on my car. The bottom of the fender forward of the metal panel brace, wants to poke outwards about an inch when bolting up the running board. My panel man says the front clip is too low, this is causing the fenders to poke out. The inner fender skirts are...

Are they the same as 32 sedan fenders? If not what are the differences. Thanks.

Whats the best way to line up the swage lines on a 33 pickup? I have heard that its best to bolt down the cab on its mounting pads and then use a couple of porta powers to jack diagonally across the door openings to line up the doors. Other people say to shim the cab to get the swages to line...

34 Sedan, has a rattle from the torque tube on the over run, ie, when decelerating. The noise disappears under acceleration. Any ideas on what it could be? The noise is definitely from the torque tube. Thx, Max

My 33 pickup leaks oil from the rear of the engine. My guess is worn main bearings combined with the labyrinth seal is the culprit. Any other reasons do you think? Thx, Max.

Any ideas where I can buy the part that fits on the drivers side of the throttle shaft that acuates the hand throttle? Mine just has a short linkage which pushes the hand thottle knob in and out as you work the accelerator pedal. Thx, Max.

Question for Kube. Is there supposed to be a fender brace from the bottom of the front fender to the chassis. This brace would be in front of the fender splash panel. It seems that my fenders angle out at the bottom rather than follow the line of the running board. I know that the fenders angle...