Recent content by Zim

Still looking

I would like to see some pictures. Thanks.

Hi, I'm putting together a '31 closed car (straight post) cowl for a huckster project. I'm looking for the piece that connects the back sides of the cowl and supports the rear edge of the fuel tank. I believe the dash rail bolts to this part. The picture below shows this piece circled in red...

Thanks, Kevin!

Thanks, spike. I thought the measurements were off based on reading old posts on this site. Now, if I can figure out what it does fit, maybe I could use it for trading stock. It's really solid!

Hi, I'm hoping to use this steel windshield frame on my '30-'31 straight windshield, closed car cowl (a work in progress). The attached pictures show the overall windshield, width, height at the ends, and height at the center. Will this frame work for my cowl? Thanks in advance for any help! Zim

Thanks for your replies and helpful information. I don't have anything else from the GS, but this tank is extremely clean and straight. Zim

Greetings all, I'm going to use the fuel tank from this cowl for my '30-'31 wagon project. This cowl was used on a Gordon Smith air compressor and was originally part of a Murray body (M654 3XXX). The cowl band uses 4 carriage bolts on each side, plus clips on top. Can you guys tell if this...

GREAT avatar, gas pumper!!!