Recent content by Zeke5180

Thanks to all for your response, much appreciated. Zeke

I have searched the forum foe a possible answer but cannot seem to find one. I have a 37 Model 78 slantback that I converted from 6-volts to 12-volts. It has the stock 221cu in engine with a two-deuce manifold. I'm using the recommended Champion spark plug, UD16. My question is, since I...

Thank you, Zeke 3.

Good morning, I have a 37 sedan slantback with the original engine and trans. I noticed on the distributor a small oil port. Mr. Haney rebuilt the distributor several years and the car is running great. My question is how often, how much and what kind of oil should I be putting in that oli...

FYI The New Vintage Precision hub puller will not work on a hub that has a protruding ring as my 37 has. Zeke

I would like to thank everyone for their reply to my question. I did go back and double check the number of bolts I removed. Several of you said ten on a side and I only removed nine on a side. My brother-in-law found the two behind the radiator hoses which I missed. I removed those two and with...

I cannot get my intake manifold to release. I've heated it up, beat it with a dead blow hammer and ran a 2 x 4 across the front fenders attaching a rachet strap to the generator bolt for additional pressure but it still stuck. yes, all the bolts are out. Any suggestions? As always, thank you...

Thanks guys.

I'm planning on replacing the intake manifold on my 37 mod 78. Is it necessary to lower the level of the radiator fluid below the intake level? Zeke

Is there a certain sequence to tighten bolts when installing an intake manifold on a stock 37 V8? I believe the torque setting is between 23 - 25 lbs.

Recently purchased the intake for my stock 1937 221. I'm not sure the best carbs to use with this manifold. Any suggestions? In searching the forum, I see mention of 48, 94 and 97's. I have a big logo 97 and although the bolt holes match up, the base on the 97 is larger than the base on the...

Kube, Bored and Stroked, That's for passing on the info about the oil pan. It's much appreciated. Looks like I'll be dropping the pan sometime in the future. Zeke

Has this happened to anyone else? I was out driving my stock 37 v8 Slantback when I needed to make a sudden stop. I noticed the oil pressure gauge showed zero pressure at the end of the stop but returned to 40 to 45 lbs quickly. Otherwise the pressure is fine while driving and during normal...

Just wanted to update on the progress of the hard brake pedal problem. I took the advice of several on the forum and shortened the push rod for the master cylinder. Shortening the push rod did the trick. Thanks to all for your help and advice. John Z.

I've converted my 37 ford mechanical brakes to hydraulic drum brakes, not power assisted. I'm using a mustang master cylinder with 1/4" lines and have a 10 lb residual valve installed. The conversion kit is a Boling Brothers product whose recommendation was for the 1/4" line. Original wide five...