Recent content by wadester

Thanks Vern that's what we figured. What about the rear seat bottom?

Thanks for the info. i believe we have located the clip. waiting for verification!! Any idea how the back seat cushion secures to the floor? I doesn't just sit in there does it?

Thanks Ed for the information. I will reach out to them!! Much appreciated...

Btt

Thanks Vern, That's why i need to be a member of the Victoria association right there. You mean i have a prototype!!! Man i need the full brace or will end up in the same boat and have a cracked back panel like we have now!! I sent you an email earlier just wondering if you received in on the...

Thanks JW, There has been some issues back there and will have to address them. My body number is 190A 2392 so it is pretty early. something just doesn't look right about the brace but i could be wrong :). All the pictures i have seen seems to have the full brace. If you run across on let me...

Looking for a 1930 Victoria rear inner metal brace that goes from the sill wood to the belt rail below the center of the rear window. Also the rear seat female latch. See picture attached of parts needed.

JW, from the looks of your pics it looks like the body wood has to assembled prior to the body being installed because it screws from the outside. is this when we adjust the cowl to get the doors to line up correctly? Wadetser

here is what i have now.

Thanks for sharing, Here is what we have now. it looks like our center brace is either wrong or its missing. where would i find one? Maybe Bert's? Thanks Im trying to figure out how to upload my picture!!

JW, Is the center metal brace a short brace. In other word it does not go all the way up to the belt line. Mine does have a small metal brace in the center but it's only about 6" tall and looks more like a corner brace. I am assuming the other two wooden tall braces will come in the body wood...

Thank you so much Vern, i am sending an email now!!!

Also been looking for some up close pictures of how the original rain gutter mounted and how the vinyl is tucked under it. What was on the car is aluminum. I am assuming that isn't original correct. i just subscribed to the Victoria association and will be getting some books in a few days or so...

ok thanks for the info!!!

Looking for some guidance. we just purchased an 1930 Victoria leatherback and there are some issues in the rear that needs addressed. my question is there a vertical brace that connects to the chassis wood and goes up to the bottom of the rear windon directly in the center of the rear of the...