Recent content by vernlee

I got every thing working , I got wires going every where , nothing in place yet , without using the black/red stripe wire at all , so I don't know what it would be for . I had a bad flasher the first time I think I shorted it out , and my switch wasn't getting a good ground , Now if I can just...

Ed , I looked it uses different colored wires , but thanks

MAG , I don't think so , the red wire that goes to brake light switch / then brake light switch to battery , then battery to X on flasher

nkaminar , I was wondering if it could be a ground myself , but you would think the directions would mention this . Also the solid black wire is to hook to the "L" terminal on the flasher according to directions

Speedway # 91062860 , Mine is just like this one only black ( same brand )

Ok , Grn. wire right front , yellow left front , Brn Right rear , orn. left rear , blu. and blk. to flasher , red to brake light switch , that is 7 wires , I have 8 wires the last one is black with a red stripe , what is it for - where does it go ? directions don't even show or mention a black...

Makes sense to me , thanks

Not familiar with a 10 cp bulb , why not just use the #67 bulb for drl

Thanks , that's pretty much what I thought

Sorry , left out it is a 1931 model A

What is the smaller bulb in the headlight assembly for ? running light ? , thinking about going with LED's but wanted to know what the small bulb does Vern

Located in Southern Michigan

Miles in MN , I'm actually seeing just the opposite , the bearing # 68-1225-A is loose on the A axle and tight going in the 40 hub .

Model A Ron , MAG , Jim Brierley , thank you so much for your thoughtful advise on my bearing question .

I'm putting 1940 brakes on the rear of my Model A , I ordered new 40 axle bearings , but they seem too loose to me , I can slide the bearing on the model a axle super easy and it has slop , it slides 1/2 way into the hub then stops , I'm sure I can press it all the way in . Does all this seem...